Cisco Aironet 1300 Series Quick Start Manual page 17

When you assign an IP address to the access point/bridge using the CLI, you
must assign the address to the BVI. Beginning in a privileged EXEC mode,
follow these steps to assign an IP address to the access point/bridge's BVI:
Command
Step 1 configure terminal
Step 2 Interface bvi1
Step 3 ip address address mask Assigns an IP address and subnet mask
Note
If you used a Telnet session to connect to the access point, you lose
your connection when you assign a new IP address to the BVI. If you
need to continue configuring the access point using Telnet, use the
new IP address to open another Telnet session to the access point.
Quick Start Guide Cisco Aironet 1300 Series Access Point
Purpose
Enters global configuration mode.
Enters interface configuration mode
for the BVI.
address to the BVI.
17