Advertisement
U
I
NSTALLATION
Parts List ..............................................................
Parts Diagram.......................................................
Helpful Hints......................................................... 3
Installation............................................................
Operation and Troubleshooting Guide...................
Warranty Information............................................
NIVERSAL
I
CONTENTS
L
UMBAR
NSTRUCTIONS
Form #3132, Rev. F, 11-02-07
2
2
4
6
8
Advertisement
Table of Contents
Troubleshooting
Subscribe to Our Youtube Channel
Summary of Contents for Rostra UNIVERSAL LUMBAR
- Page 1 NIVERSAL UMBAR NSTALLATION NSTRUCTIONS CONTENTS Parts List .............. Parts Diagram............Helpful Hints............3 Installation............Operation and Troubleshooting Guide....Warranty Information..........Form #3132, Rev. F, 11-02-07...
-
Page 2: Parts List
PARTS LIST BLADDER SWITCH PUMP/POUCH HARNESS HDW PKG 250-02038 Standard 250-02054 250-02047 250-02046 250-02044 250-02042 Front Mount PARTS DIAGRAM 12in. (30.5cm) Standard Bladder Assy (250-1453 KIT) 10.25in. (26.0cm) Pump/Pouch Connector Switch Assy Pump/Pouch Assy Front Bladder Assy (250-1454 KIT) Main Harness Fused Harness... - Page 3 HELPFUL HINTS 1. B EFORE TARTING NSTALLATION Familiarize yourself with the installation instructions and lumbar seating system components (switch, harness, pouch and bladder) NOTE: F OR EASE OF INSTALLATION YOU MAY REMOVE THE SEAT FROM THE VEHICLE THIS STEP IS PERFORMED YOU MUST ENSURE THAT ON RE INSTALLATION ’...
- Page 4 INSTALLATION BLADDER INSTALLATION NOTE: LADDER PERFORMANCE DEPENDS GREATLY ON POSITIONING AND HOW WELL THE BLADDER IS SECURED IN PLACE To detach the seat cover apply one of the following 12in(30.5cm) steps: A. J-Clips: Insert panel puller into channel (in the seam on bottom edge of seat back) and pull the standard/extended other side of the seam over the channel to...
- Page 5 2. Remove center console or side seat panel as needed. 3. Cut a 1/2” x 1-3/8” hole in the console IGURE or the seat side panel using ROSTRA center console switch tool (250-1428) or using T EMPLATE PAGE 4. Place the bezel from hardware package onto switch.
- Page 6 INSTALLATION Switch Template A (Actual size) WIRING HARNESS INSTALLATION SWITCH INSTALLATION: F 5 & 6 IGURES 1. Remove side scuff plate and kick panel. 2. Starting at the scuff plate, route three pin pump connector end of harness under carpet to exit through opening under the seat, and connect to pump. For seat mount switch connect three pin switch connector end of harness to switch.
-
Page 7: Troubleshooting
OPERATION AND TROUBLESHOOTING TROUBLESHOOTING ! WARNING ! Using a Test Light may cause damage to the vehicle. IRING IAGRAM R = Red = Power Y = Yellow = Valve B = Black = Ground GR = Green = Pump RE-CONNECT NEGATIVE BATTERY CABLE. 1. - Page 8 36 MONTH/36,000 MILE LIMITED WARRANTY Rostra Precision Controls, Inc. (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven to have defective material or workmanship within 36 months or 36,000 miles of the original purchase, such defect(s) will be repaired or replaced (at the Company’s option) without charge for the parts.
Need help?
Do you have a question about the UNIVERSAL LUMBAR and is the answer not in the manual?
Questions and answers