Product Diagram; Add Water - TaoTronics TT-AH002 User Manual

Product Diagram

① Nozzle
② Water tank
③ Water intake
④ Filter
⑤ Handle
⑥ Water sink
⑦ Power cable
⑧ Transducer
⑨ Base
⑩ Floater
Fixer for oater
LED Indication
Switch
Important
- Please leave the humidi er in the room for at least half an hour before use, especially
when the outdoor temperature is below 5℃/41°F;
- Do not turn on the unit when no water is in the tank, it will cause serious damage;
- Do not touch the water in the sink or any component of the sink while the unit is working.

Add Water

- Remove the water tank from the base;
- Twist to loosen the switch of the lter on the bottom of the water tank and ll water in
the tank; then twist the lter back on;
- Put the tank back on the base;
Note: Do not ll the water tank via the nozzle.
How to Use
- Turn the switch clockwise pass the "ON" position. A tick sound indicates the humidi er
has been turned on. The LED indicator will be green to show it has started working;
- Keep turning the switch clockwise to increase evaporation level. Maximum
evaporation is 300mL/h;
- Turn the switch counterclockwise to the "OFF" position to turn off the humidi er. The LED
indicator will be off to show it has stopped working.
Low Water Protection
When the water level drops below a minimum amount, the LED indicator will become
red. When water is depleted, the humidi er will automatically power off.
Clean the Water Tank
1. Make sure the unit is turned off;
2. Remove the water tank from the base;
3. Rinse the tank with clean water and wipe off any water on the outside of the tank
before putting it back.
03/04