Kenmore 253.70722 SERIES Use & Care Manual page 7

First Steps
_ CAUTION
To allow door to close and seal properly,
DO NOT let food packages extend past
the frant of shelves.
3.
Slide the shelf grommet into the
grommet already in the unit wall until
it is flush.
To install the shelf grommet to the shelf:
1. With the wire shelf installed, press the
shelf grommet down onto the wire that
is anchored into the appliance wall. Be
sure to keep the larger end of the shelf
grommet away from the wall.
2.
Push the shelf grommet onto the wire
until it snaps in place.
Door Removal
If door must be removed:
1. Gently lay the unit on its back, on a
rug or blanket.
2. Remove 2 base screws and base panel.
3. Remove wire from clips on bottom of
cabinet if required.
4. Unplug connector, if required, by
holding the cabinet connector in place
and pulling the door connector out.
5. Remove bottom hinge screws.
6. Remove plastic top hinge cover.
7. Remove screws from top hinge.
8. Remove top hinge from cabinet.
9. Remove door and bottom hinge
from cabinet.
10. To replace door reverse the above
order, and securely tighten all screws
to prevent hinge slippage.
7