Page 1
CROWN G17 AUTO SCRUBBER OPERATOR'S MANUAL IMPORTANT: READ OPERATOR'S MANUAL CAREFULLY Please fill out & return your warranty card! DP80017 Diamond Products www.diamondproductsus.com Printed in the U.S.A.
Page 2
Diamond Products US. Warranty Information Thank you for purchasing a Diamond Products US product. Warranty registration is quick and easy. Your registration will allow us to serve you better over the lifetime of the product. To register your product, email your warranty card information to: info@diamondproductsus.com...
When unpacking and unloading, or during transportation, please take care to avoid hitting the solution valve. Part A in the fi gure on the right. Check if the machine is equipped with the following items: Machine User manual Squeegee assembly Brush/pad driver Diamond Products Operator's Manual...
In order to ensure safe and proper operation of the machine, it is advised that an authorized service provider perform the scheduled maintenance according to the maintenance schedules outlined in this manual. This machine must be properly disposed of in accordance with local laws and regulations (please refer to machine disposal section). Diamond Products Operator's Manual...
Weight with empty tanks 70kg Gross weight of the machine ready for use 120kg Brush motor power 750W Brush speed 150rpm Brush /pad-holder Maximum pressure 32kg(Max) Packing size (Lx W x H) 1200 x 610 x 1170mm Diamond Products Operator's Manual...
Recovery tank lid Recovery tank Solution fi ll Brush deck Brush / pad-holder Vacuum motor Brush motor 8” wheel Vacuum tube Electric Box Float fi lter Water level site tube CONTROL PANEL Power switch Vacuum switch Solution switch Diamond Products Operator's Manual...
Page 8
fl oor or the downward pressure is relatively light, adjust the handle in a clockwise direction until the whole length of the rear squeegee strip touches well with the fl oor. The front squeegee strip should lightly touch the fl oor. Diamond Products Operator's Manual...
Each safety switch is capable of controlling independently the operation of the brush. In use, it facilitates the control of the operation of the machine. Operators are encouraged to fi nd the most comfortable position their hands. Diamond Products Operator's Manual...
(25) to check if the fl oat has returned to the water surface. Close the recovery tank cover (25), and press the power switch (38 and 39) to turn on the main power and the vacuum motor. Diamond Products -10- Operator's Manual...
After the fi rst 9 hours of use, please check components to ensure all connections (electrical & mechanical) are tight & check for any damage that may have occurred during operation. Check for water leakage. Diamond Products -11- Operator's Manual...
Check if the front squeegee blade (C) and the rear squeegee blade (D) are intact, and if there are broken edges and cracks. Replace them if necessary (refer to the steps in the following section). Re-install the squeegee in the reverse order of the above FIGURE 10 Diamond Products Operator's Manual Diamond Products -12- Operator's Manual...
Check the brush for wear & if necessary, replace the brush. Check the pad driver for wear & if necessary, replace the pad driver. Remove and clean the rear squeegee and check for wear, nicks or tears, replace as required. Diamond Products -13- Operator's Manual...
Page 14
The seal / gasket (G) of the recovery tank allows the tank to create a vacuum. It must be completely sealed to be able to effectively suck the wastewater from the fl oor. Check if the receiving surface of the sealing strip (G) is intact and seals adequately. Close recovery tank lid (A). FIGURE 11 Diamond Products -14- Operator's Manual...
/ gasket Squeegee leaving marks Debris fragments under the squeegee blade Remove the fragments Squeegee blade worn, cracked or brittle. Replace the squeegee blade Balance of squeegee not adjusted Adjust the balance Diamond Products -15- Operator's Manual...