Installation - Marathon MBWC24 Owner's Use And Care Manual

MBWC24-2D
1. Adjustable glass shelves
2. Stainless steel handles
3. Ventilation grill
4. Adjustable wooden shelves
Before using your new Wine and/or Beverage Cooler, we recommend leaving Cooler door open and un-
plugged for 24 hours prior to installation or use. This will allow time to clear any residual odors from the
interior liner and hardwood shelves.
Your Premium Marathon Wine and/or Beverage cooler is engineered for built-in or freestanding installation.
The front bottom vent is the ventilation grill and must not be covered.
Choosing the right location for your Marathon Wine and/or Beverage Cooler is important. We highly recom-
mend the following location criteria:
• Unencumbered and well ventilated
• Dry area, not too damp or humid – ideally at maximum 65% relative humidity for peak performance and
reduced sweating on the interior door when opening. Preferably not in a laundry room, pantry, garage
or bathroom.
• Flat, level floor
• Approved electrical outlet (preferably with surge protector) within 3 feet of the Wine and/or beverage cooler.
• Minimum 1 meter from any microwave oven. Certain microwave ovens do not have a wave interference
shield. When placed too close to the wine or beverage cooler, the performance may be affected.
4
Your Marathon wine and/or Beverage Cooler is equipped with a three prong power cord which has a ground
wire. The plug should never be altered or used with an extension cord or power bar. Improper use of the
grounding plug can result in the risk of electric shock. Consult a qualified electrician or service person if the
grounding instructions are not completely understood. If the supply cord is damaged, it must be replaced by
a qualified person in order to avoid electrical hazard.

Installation

CAUTION
4 4
! !
MBWC24-2D
4 4
! ! !
MBWC24 | MWD24-D | MBWC24-2D
4
!