Table of Contents
Advertisement
2. REMOVAL OF DVD DECK PARTS
NOTE
1. Disassemble only the DVD DECK PARTS parts listed
here. Minute adjustments are needed if the
disassembly is done. If the repair is needed except
listed parts, replace the DVD MECHA ASS'Y.
2-1: TRAVERSE ASS'Y/LOADING MOTOR PCB ASS'Y/
PLATE TRVS UD (Refer to Fig. 2-1-A)
1. Remove the screw (1).
2. Remove the screw (2).
3. Unlock the 5 supports (3).
4. Remove the Insulator (R) from the Loader Ass'y.
5. Remove the Traverse Ass'y and Plate Trvs Ud.
Traverse Ass'y
Plate TRVS UD
Loader Sub Ass'y
• Screw Torque: 1.0 ± 0.3kgf•cm (screw(1))
• Screw Torque: 3.0 ± 0.3kgf•cm (screw(2))
NOTE
1. In case of the Traverse Ass'y installation, hook the wire
on the Loader Ass'y as shown Fig. 2-1-B to Fig. 2-1-C.
Loader Ass'y (Top side)
Check Lock
DISASSEMBLY INSTRUCTIONS
(1)
Insulator (R)
(2)
(3)
(3)
(3)
(3)
Fig. 2-1-A
Check Lock
Check Lock
Fig. 2-1-B
Check Lock
2.2: HOLDER TRAVERSE/INSULATOR (F)/
INSULATOR (R)/FEED RACK ASS'Y/
PCB630/GEAR MIDDLE/GEAR FEED/
FEED MOTOR/GEAR MOTOR
(Refer to Fig. 2-2-A)
1. Remove the Holder Traverse.
2. Remove the Insulator (F).
3. Remove the Insulator (R).
4. Remove the screw (1).
5. Remove the Feed Rack Ass'y.
6. Remove the screw (2).
7. Remove the PCB630.
7. Remove the PCB630.
8. Unlock the support (3).
9. Remove the Gear Middle.
10. Remove the screw (4).
11. Remove the Gear Feed.
12. Remove the 2 screws (5).
13. Remove the Feed Motor.
14. Remove the Gear Motor.
Gear Feed
(2)
PCB 630
Insulator (F)
Holder Traverse
• Screw Torque: 1.3 ± 0.3kgf•cm (Screw (1))
• Screw Torque: 3.0 ± 0.3kgf•cm (Screw (2))
• Screw Torque: 1.0 ± 0.3kgf•cm (Screw (4), (5))
B2-1
B2-1
Fig. 2-1-C
(4)
Gear Middle
(1)
Feed Rack Ass'y
(5)
(3)
(5)
Insulator (R)
Traverse Ass'y
Gear Motor
Feed Motor
Insulator (F)
Fig. 2-2-A
Advertisement
Table of Contents
