Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Advantage S-250
Summary of Contents for Advantage S-250
- Page 1 ADVANTAGE ADVANTAGE POWER-AMPLIFIER S-250 STANDBY...
-
Page 2: Table Of Contents
Table of contents Introduction “Burn-In” Design Balanced signal transmission Unpacking Placement Cleaning Rear panel Balanced Inputs Unbalanced Inputs Output Connectors Balanced / Unbalanced switch Data Com AC Line Cord Recepatcle Front panel Standby LED / Indicator Trouble Shooting Warranty Obtaining Service ADVANTAGE... - Page 3 EMC (Electromagnetic Compatibility)and LVD (Low Voltage Directive)standards of the European Community. The information contained in the manual is subject to change without notice.The most current version of this manual will be posted on our web site at http://www.bladelius.com. ADVANTAGE...
-
Page 4: Introduction
5-6 weeks of operation, in order to speed the "burn-in" process. For best results, the S-250 should be left on or in the standby mode at all times. The unit should not be switched off via the master ON/OFF switch unless the unit will not be being used for a significant period of time (during vacations, etc.). -
Page 5: Unpacking
We suggest that you to keep your box and shockabsorbers . Save your plastic bag, inserts, and carton. You may need these later for transporting the S-250 or for shipment in the event it ever requires factory service. Record... -
Page 6: Rear Panel
“balanced” and vice versa in case of use of unbalanced The Data com is used to exchange information with other Data Com ADVANTAGE products. If you for example connect your (3.) power-amplifier to the S-2 preamp you will be able to get information about the temperature on the heatsinks or to put the power amplifier in stand-by mode. -
Page 7: Front Panel
Front panel For best results, the S-250 should be left on or in the standby Standby (1.) mode at all times. The unit should not be switched off via the master ON/OFF switch unless the unit will not be being used for a significant period of time (during vacations, etc.). -
Page 8: Trouble Shooting
! Contact your dealer. 1.)If the LED starts to flash during operation it means most likely that the S-250 is overheated. Try turning the master switch off for a while and then turn it back on. In the event of a fuse failure, locate the fuse access hatch under the AC mains plug. -
Page 9: Warranty
Obtaining Service contact your dealer. Your dealer will then decide whether the problem can be remedied locally, or whether to contact ADVANTAGE for further service information or parts, or to obtain a Return Authorization. Important! Return authorization must be obtained from our Technical Services Department BEFORE a unit is shipped for Service. - Page 10 ADVANTAGE Manufactured in Sweden...
Need help?
Do you have a question about the S-250 and is the answer not in the manual?
Questions and answers