Before Operating; Starting - Beko BZ 77F User Manual

Hide thumbs Also See for BZ 77F:
Table of Contents

Advertisement

4

Before operating

Starting

Final Check
Before
you
refrigerator check that:
1. The front feet have been adjusted
so the appliance is level.
2. The interior is dry and air can
circulate freely at the rear.
3. Clean the interior as recommended
under "CLEANING AND CARE."
4. Insert the plug into the wall socket
and switch on the electricity supply.
Avoid accidental disconnection by
taping over the switch. Green light
will glow and the compressor will
start running in about five minutes.
5. You will hear a noise as the
compressor starts up. The liquid
and gases sealed within the
refrigeration system may also
give rise to noise, whether the
compressor is running or not which
is quite normal.
6. We recommend that you set the
thermostat halfway between Min.
and Max. (See section Temperature
Control and Adjustment).
7. Do not load the appliance
immediately it is switched on.
Wait until the correct storage
temperature has been reached.
We recommend that you check
the temperature with an accurate
thermometer (see; Temperature
Control and Adjustment)
start
using
the
8. If there is a power failure do not
open the door. Frozen food should
not be affected if the failure lasts
for less than 11 hours. If the failure
is longer, then the food should
be checked and either eaten
immediately or cooked and
re-frozen.
9. If you find the freezer door difficult
to open just after you have closed
it, don't worry. This is due to the
pressure difference which will
equalise and allow the door to open
normally after a few moments.
10. You will hear a vacuum sound just
after closing the door. This is quite
normal.
11. When you switch on, the appliance
will not start immediately, because
the appliance incorporates a
protection device in the electronics -
wait for about 5 minutes.
16
EN
then

Advertisement

Table of Contents
loading

Table of Contents