Page 1
Thanks for your favor in our product. This manual is helpful for you to quickly know how to use the product. Please refer to the corresponding Feature Book for detailed features and operations. This manual is applicable to the following product: MD65X Digital Mobile Radio (X may represent 0,2, 5, 6 or 8)
Third Party products and contents involved in this manual. If you have any suggestions or would like to learn more details, please visit our website at: http://www.hytera.com. RF Radiation Information This product must be restricted to operations in an Occupational/Controlled RF exposure Environments.
International Commission on Non-Ionizing Radiation Protection (ICNIRP) 1998. FCC Regulations Federal Communication Commission (FCC) requires that all radio communication products should meet the requirements set forth in the above standards before they can be marketed in the U.S, and the manufacturer shall post a RF label on the product to inform users of operational instructions, so as to enhance their occupational health against exposure to RF energy.
50% of the time, although the hardware support transmission up to 100% of the time in analog mode and up to 50% in digital mode. EU Regulatory Conformance EU Regulatory Conformance The equipment is in compliance with the essential requirements and other relevant provisions of the Directive 1999/5/EC.
Power Cord Documentation Kit Note: The GPS antenna is the standard accessory for the MD65X with GPS feature. The frequency band is marked on the label of antenna; if not, please refer to the label on the radio for frequency band information.
2. Product Overview Radio Unit Caution: GPS antenna connector is for MD65X mobile radio with GPS feature only. Do not block the ventilation hole of the fan. Clean the fan regularly. Do not use stop the fan with hard objects such as screwdriver to avoid fan damage.
Drill the mounting hole cautiously to avoid damage to the vehicle wiring and other parts. Please connect Hytera supplied antenna and power cord to the product, before you install it in the bracket. And make sure the antenna and power cord are dedicated for Hytera digital radios.
Page 8
Part Name Part Name Radio Unit Power Interface Locking Knobs Power Cord (black) Mounting Bracket Power Cord (red) 4.8×20mm Self-tapping Screws Fuse Remote Speaker Microphone RF Antenna Connector 4×16mm Self-tapping Screws GPS Antenna Connector Remote Speaker Microphone Hanger...
4. Indications The LCD display and LED indicators on the remote speaker microphone indicate the operation status of the radio. LCD Icon Icon Name Icon Display Product Status RSSI Icon More bars indicate better signal strength. The GPS feature is enabled, and valid GPS data is received.
Page 10
LED Indication Product Status green. indicator glows Transmitting. red. indicator glows Receiving. green. indicator flashes Scanning or roaming. orange slowly. indicator flashes Emergency. orange rapidly. indicator glows The call is established successfully and you can hold down the PTT key to talk. orange.
5. Basic Operation Powering On/Off Method 1 Method 2 Adjusting the Volume 步骤 3 Press the key on the remote microphone speaker until the icon is shadowed. 步骤 4 Press the key to lower the volume and press the key to increase it. Selecting a Zone You can include a group of channels with the same property into a zone for convenient management.
Page 12
步骤 1 Press the key on the remote microphone speaker until the TX power level Icon (e.g. is shadowed. 步骤 2 Press the key to switch power level.
6. Initiating a Call After the radio is powered on, you can make different kinds of calls. To ensure optimal volume of the receiving radio, keep the microphone about 2.5 to 5 centimeters away from your mouth when transmitting. Calling on Digital Channel You can initiate a private call, group call or all call (your radio must be programmed to allow you to use the all call service) through the same operations on digital channel.
Page 14
Note: The Call Hold Time (the duration of LED indicator glowing orange) is preset by your dealer. If neither party talks before this duration expires, the call will end. Calling on Analog Channel (No Signaling) On the analog channel without signaling, the calling operations are the same as that on the digital channel.
7. Feature Description Available features of this radio are listed below. Please refer to the corresponding Feature Book for details. Feature Type Detailed Feature Radio setting: Power Level, LED Indicator and Alert Tone Convenient functionality: Shortcuts, One Touch Call and VOX ...
Page 16
Feature Type Detailed Feature Voice services (See {0>模拟信道呼叫(无信令) <}100{>Calling on Analog Channel (No Signaling) in this manual) Security Signaling API Features Developed Accessory Connector with Third Party...
8. Troubleshooting Phenomena Analysis Solution power cord Power-on Failure. Properly connect the power cord. disconnected. Increase the volume via the remote speaker Low volume level. microphone. During receiving, The antenna may be loosened Turn off the product, re-install the antenna and the voice is weak, or improperly installed.
Page 18
Move to an open and flat area to try again. position. If the above solutions cannot fix the problems, or there are other questions, please contact Hytera or the dealer for more technical support.
9. Care and Cleaning To guarantee optimal performance as well as a long service life of the product, please follow the tips below. Product Care Do not pierce or scrape the product. Keep the product far away from substances that can corrode the circuit. ...
The following items are the main optional accessories for the radio. For more information of other accessories, please consult your local dealer. Caution: Use the accessories specified by Hytera only. If not, the Company shall not be liable for any loss or damage arising out of use of unauthorized accessories.
Need help?
Do you have a question about the MD65X and is the answer not in the manual?
Questions and answers