Advertisement
Car Polisher-Operating
3. Always start and stop the polisher on or
against the car surface (see dia 4).
Dia 4
4. Hold extension lead over shoulder and do
flat surfaces first ie: bonnet boot and roof.
Cover areas quickly with broad sweeping
strokes in a criss-cross pattern. Do not press
down on polisher. The machine s action, not
pressure, does the best job (see dia 5).
Dia 5
1 1
3 3
2
5. Work next on smaller surfaces (doors etc.)
Always keep the mains lead over the shoulder
or let it hang to the ground when working on a
vertical surface making sure it is well clear of
the moving polishing head. For less accessible
surfaces (such as wing mirrors, door handles)
remove the polishing bonnet and polish these
areas by hand (see dia 6).
Dia 6
6. Finally remove the terry-cloth application
bonnet and fit the synthetic wool polishing
bonnet onto the polisher, (see dia 7).
Dia 7
7. Use long, sweeping strokes in a criss-cross
pattern to bring out the shine. Do not press
hard. Let the polisher do the work (see dia 8).
Dia 8
-6-
Plug fitting
Your Car Polisher is supplied with a fitted plug, however if you should need to fit a new plug follow
the instruction below.
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
Blue - Neutral Brown - Live
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured blue must be
connected to the terminal which is marked with
N .
The wire which is coloured brown must be
connected to the terminal which is marked with
the letter L .
No connection is to be made to the earth
terminal of the plug.
If a 13 AMP (BS 1363/A) Plug is used, a 5 AMP
Fuse must be fitted, or if any other type of plug
is used a 5 AMP Fuse must be fitted, either in
the Plug or Adaptor, or on the Distribution
Board.
Note If a moulded plug is fitted and has to be removed take great care in disposing of the plug and
severed cable, it must be destroyed to prevent engaging into a socket.
Environmental Protection
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authority or retailer
for recycling advice.
If faults cannot be remedied, contact the Helpline on 020 83916767
Helpline@hilka.co.uk
GUARANTEE
This product is guaranteed for domestic use for a period of 12 months against faulty manufacture or materials. This
guarantee does not affect the statutory rights of the consumer. If in the event of any problem occurring please
contact our Helpline at the number above for advice. This product is not guaranteed for HIRE purpos
CHALLENGE TOOLS (UK) LTD.
1 ROEBUCK PLACE, ROEBUCK ROAD, CHESSINGTON, SURREY KT9 1EU
5 AMP
FUSE
BLUE
(NEUTRAL)
BROWN
N
(LIVE)
L
OUTER
SLEEVE
CABLE GRIP
Issue 3 M.L-11/2005
-7-
Advertisement
