HID EH400 Installation Manual

15370 Barranca Parkway
Irvine, CA 92618-2215
USA
Edge is the next evolution in access control hardware solutions. A true IP solution that meets the demands of open architecture, IP-centric
environments, Edge provides fully distributed intelligence and decision making right to the door, leveraging the IT infrastructure to the
maximum extent possible. Wire the Edge device to Hi-O interface modules to provide connectivity to electronic door components and
access control readers.
Hi-O involves devices with built-in intelligence and a CANbus that links all the devices together. Hi-O CANbus data traffic can be password
protected and encrypted, or both. Each Hi-O device (such as the push plate, electric strike, card reader, door operator) is connected to the
CANbus by a single, four-wire cable. Two of the wires supply power and the other two are used for data communication.

Specifications

CONNECTION PARAMETER
Voltage - Nominal
PoE Power Current - Normal Standby
(input) Condition (NSC)
Current - Maximum
Voltage
Current - Normal Standby
Condition (NSC)
Current - Normal Standby
+DC (input)
Condition (NSC)
Current - Maximum
Current - Maximum
Voltage - Nominal
Current - Maximum
CAN PWR
(output)
Voltage - Nominal
Current - Maximum
CONDITIONS VALUE
- 48 VDC
CAN PWR - not loaded 75 mA
CAN PWR - max load 275 mA
- 12 VDC - 24 VDC
12 VDC
190 mA
CAN PWR disconnected
24 VDC
110 mA
CAN PWR disconnected
12 VDC 2.2 A
24 VDC 2.1 A
PoE 24 VDC
PoE 300 mA
+ DC + DC
+ DC 2 Amp - AUX limited
EdgeReader® and EdgePlus®
Models: EH400, EHR40, EHRP40, EH400-K
ER40C, ERP40C
© 2009 HID Global Corporation. All rights reserved.
OPERATING
TEMPERTURE
Hi-O CAN Bus
32° - 122°F
(0° - 50° C)
RJ45
Edge
I
nstallatIon
82000-920, Rev A.1
December 10, 2009
CABLE LENGTH
= 30 ft (9 m) - 22 AWG ● 0.65mm ● 0.33mm
= 75 ft (23 m) - 18 AWG ● 1.02mm ● 0.82mm
= 328 ft (100 m) - Category 5 K
G
uIde
2
2