Summary of Contents for Long range system TX-7470-C232
- Page 1 U S E R M A N U A L TX-7470-C232 PAGING System Transmitter Long Range Systems, LLC. LRSUS.COM | 800.437.4996 | 214.553.5308 011317...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Installation and Setup ..............................2 Set Restaurant ID..............................4 Repeat Delay ................................ 5 High Power Setting .............................. 5 Positioning and Installing the Repeater ........................6 Service Questions and Answers ............................7 Warranty ..................................7 FCC Statement ................................8 Terms &... -
Page 3: Installation And Setup
INSTALLATION AND SETUP Basic Installation 1) Connect the antenna 2) Plug the 12V power supply into the side of the Transmitter. 3) Connect the serial cable from the connector on the Transmitter to the serial port on the host computer. 4) Note the COM Port that the serial cable is connected to on the host computer. -
Page 4: Set Restaurant Id
Set Restaurant ID This must be set correctly to page pagers. To set the Restaurant ID, type RID,x and press ENTER twice. X is the Restaurant ID. Example: To set an ID of 2, type RID,2 and press ENTER twice. Example Restaurant ID to 2 HyperTerminal Output Showing ID as 2 Type STAT and press ENTER... -
Page 5: Repeat Delay
Repeat Delay To turn ON Repeat Delay, type RPTDLY,1 and press ENTER twice. To turn OFF Repeat Delay, type RPTDLY,0 and press ENTER twice. Example Repeat Delay ON Status View Showing Repeat Delay ON High Power Setting To change the Power Setting, type HWPR,x and press ENTER twice. X is the Power Setting, a value of 0 to 4. -
Page 6: Positioning And Installing The Repeater
POSITIONING AND INSTALLING THE REPEATER Note: The best place to mount your repeater is on a ceiling or wall that is very high. The idea is to get the signal as high as possible so it “umbrellas” the guest and thus all pagers can receive it. The repeater operates at its best when installed at the “fringe”... -
Page 7: Service Questions And Answers
SERVICE QUESTIONS AND ANSWERS What to do if the system malfunctions Should your paging system ever fail or should you need additional paging supplies, call Long Range Systems at (800) 437-4996. System Repair After Warranty Expiration Call Long Range Systems before sending a non-warranty item in for repair. Ordering Additional Pagers Call Long Range Systems at 800.437.4996 or 214.553.5308 to place your order. -
Page 8: Fcc Statement
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired opera- tion. -
Page 9: Terms & Conditions
TERMS & CONDITIONS GENERAL TERMS AND CONDITIONS FOR LONG RANGE SYSTEMS, LLC (FOR PURCHASERS) These general terms and conditions (“General Terms and Conditions”) govern all persons (“Purchasers”) that purchase or license equipment, software, firmware, and/or services (collectively “Deliverables”) from Long Range Systems, LLC (“LRS”). - Page 10 Limitation of Remedies. In the event of any breach of any express warranty made herein, LRS may at its option repair or replace any defective Deliverable or refund the money that Purchaser paid for it. LRS’s total liability for any defect in any Deliverable or for any other breach of any of its duties and obligations to Purchaser shall be lim- ited to the amount of money that was paid for the defective Deliverable or the other duty or obligation.
- Page 11 No Assignment or Transfer. The rights and benefits provided under these General Terms and Conditions, as well as under any agreement that incorporates them, shall not be assigned without the express written permission of LRS. Similarly, the Deliverables may not be transferred to any other person, without the express written permis- sion of LRS.