GE DDE8200G Use And Care Manual page 11

PROBLEM
KNITS
PERMANENT PRESS
AND "NO-IRON"
ITEMS
POSSIBLE CAUSE AND REMEDY
can occur in knit fabrics that have been improperly stretched
and elongated by the manufacturer. When this occurs, garment maybe pressed back into
shape after each wash and dry cycle.
Progressive or delayed shrinkage
.
gradually removed by laundering. Maybe noticed in older garments that have been
Shrinkage caused by overheating
shaped. When washing, drying or ironing temperatures exceed the temperatures used to
shape set, shrinkage may occur. This cannot be corrected, but it can be prevented by
washing in cold or warm water; drying on low heat.
Leaving clothes in dryer after tumbling stops. Remove clothes promptly and hang
them immediately.
Too many items in dryer. Dry only one washer load at a time. Do not combine loads.
Too fe items in d~er.
w
if dry, to insure proper tumbling.
with lighter Permanent Press items, such as shirts or blouses. Do not wash or dry
Permanent Press with regular laundry.
Too many clothes in washer. Items must have room to move freely. Permanent Press
loads should always be smaller than regular loads.. .no more than medium loads.
. Use of incorrect wash and dry cycles. Use Permanent Press Wash Cycle which provides
a cool-down rinse to minimize wrin~ing. Also, use Permanent Press Dry Cycle.
Incorrect water level. Use
for small load.
. Washing repeatedly in too hot water. Wash in cool or warm water with plenty of detergent.
is caused when starch or sizing (in some fabrics) is
occurs in certain knit fabrics that have been heat-
or more similar articles, even
items, such as work clothes,
medium level or half full