gaTE OPERaTORS
Programming to a gate Operator with a Program/LEaRn Button
The Program/LeaRn button is typically located on the control board of the operator or an external receiver. For help locating your
Program/LeaRn button contact your gate operator manufacturer.
The images throughout this manual are for reference only and your product may look different.
1
Start with your gate closed.
IMPORTANT: The remote will activate your gate during
programming. Ensure gate is clear of ALL obstructions.
3
P ress and release the Program/LEARN button* on your
gate operator. The Program/LEARN LED will illuminate.
* D epending on your product, the Program/LEARN button may have a different
name (use the button for programming remote controls).
5
Wait for the gate to move or the program/LEARN LED on
the gate operator blinks, then press and release either of
the buttons on the remote.
2
P ress and hold bottom button on the remote control until
the blue LED stays solid (approximately 15 seconds) then
release the button.
4
On the remote control, press and release the button that
you would like to program twice. The blue LED will blink
for up to 60 seconds.
Program/LEARN
LED
Button*
Program/LEARN
LED
6
Test the remote control by pressing the button you
programmed in step 4. If the gate operator does not
activate, repeat the programming steps.
12
LED
Bottom Button