Lenovo LJ2500 User Manual page 10

WARNING
THIS PRINTER MUST BE PROPERLY EARTHEN.
The wires in the mains cord are colored in accordance with the following
code:
$ Green and yellow:
$ Blue:
$ Brown:
The colors of the wiring in the power lead of this printer may not correspond
with the markings which identify the terminals in your plug. If you need to fit
a different plug, proceed as follows.
$ Remove a length of the cord outer sheath, taking care not to damage
the colored insulation of the wires inside.
$ Cut each of the three wires to the appropriate length. If the construction
of the plug permits, leave the green and yellow wire longer than the
others so that, in the event that the cord is pulled out of the plug, the
green and yellow wire will be the last to disconnect.
$ Remove a short section of the colored insulation to expose the wires.
$ The wire which is colored green and yellow must be connected to the
terminal in the plug which is marked with the letter "E" or by the earth
symbol or colored green or green and yellow.
$ The wire which is colored blue must be connected to the terminal which
is marked with the letter "N" or colored black or blue.
$ The wire which is colored brown must be connected to the terminal
which is marked with the letter "L" or colored red or brown.
$ The outer sheath of the cord must be secured inside the plug. The
colored wires should not hang out of the plug.
Ground
Neutral
Live
ix