30"/36"/42"/48" island-mount range hood (20 pages)
Summary of Contents for Home Depot 168 SERIES
Page 1
Installation Guide and Users Manual Elite Built-In Series (Insert Liners - E50/E70) IMPORTANT: Read and save these instructions. NOTICE: Installer: Leave this guide with the homeowner Homeowner: Keep this guide for future reference Built-In Range Hood Rev. 1052u.3a...
Important Safety Notice Read all Instructions before Installing and operating this appliance • The installation in this manual is intended for qualified installers, service technicians or persons with similar qualified background. Installation and electrical wiring must be done by qualified profession- als and in accordance with all applicable codes and standards, including fire-rated construction.
Page 3
Important Safety Notice Read all Instructions before Installing and operating this appliance • Clean ventilating fan frequently. • Always use appropriate cookware and utensils size. • Always use cookware appropriate for the size of the surface element. To reduce the risk of injury to persons in the event of a stove top grease fire: •...
Venting Requirements Height & Clearance • Vent system must terminate to the out- side (roof or side wall), unless using a recirculating kit. Cabinet • Do not terminate the vent system in an attic or other enclosed area. • Do not use 4” (10.2 cm) laundry-type wall caps.
IMPORTANT: • A minimum of 6” round (standard for this range hood) or 3-1/4 x 10” rectangular duct (purchased separate- ly) must be used to maintain maximum airflow efficiency. • Always use rigid type metal/aluminum ducts if available to maximize airflow when connecting to provided duct.
Venting Methods • This built-in range hood is factory set for venting through the roof or wall. For non-vented (re-circulating) installations, see Ductless Conversion (Non-Vented) below. • Vent work can terminate either through the roof or wall. To vent through a wall, a 90° elbow is needed. IMPORTANT: •...
Charcoal Filter Installation Methods NOTE: The charcoal filters might preinstalled if you purchased the range hood with re-circulating kit from us. Remove grease filter on hood. Position the charcoal filters onto each side of the motor and turn until it locks. Re-install aluminum filters. Charcoal filters should be replaced after 120 hours of use (or approximately every 2 to 3 months based on the average of 1 to 2 hours of daily cooking time).
Installation Excessive Weight INSTALL THE HOOD Require two or more person to move and Due to excessive weight, two or more person is recommended for this step. install this range hood. Spinal or other bodi- ly injuries could occur if it is not followed. NOTE: the hood has to be installed, inside the cabinet, at minimum 1-1/2”...
Range Hood Operations Low Speed High Speed Power Switch Medium Speed Light Switch Turn On: • Press the speed control (Low Speed, Medium Speed, High Speed) switch to select the desired level of power. Once button is pressed, the previous speed mode will cancel. •...
Troubleshooting If the range hood does not operate after installa- • Check if the range hood has been plugged in, make tion: sure that all power has been turned back on and all electrical wiring are properly connected. • Swap out light assembly to working ones to deter- mine whether it is caused by defective bulbs.
Use and Care Information WARNING — TO REDUCE THE RISK OF FIRE, ELEC- lowed to accumulate on fan or filter. TRIC SHOCK, OR INJURY TO PERSONS, OBSERVE Use proper pan size. Always use cookware appropriate for THE FOLLOWING: Use this unit only in the manner in- the size of the surface element.
Maintenance SAFETY WARNING: Never put your hand into area housing the fan while the fan is operating! For optimal operation, clean range hood and all baffle/spacer/filter/grease tunnel/oil container regularly. Regular care will help preserve the appearance of the range hood. Cleaning Exterior surfaces: •...
Warranty TO OBTAIN SERVICE UNDER WARRANTY: You must present proof of original purchase date. Please provide an original dated proof of purchase (sales receipt / invoice) in order to obtain service under warranty. One Year Parts Warranty: For one year from the date of original purchase, your local reseller will provide free of charge, non-consumable replace- ment parts or components that failed due to manufacturing defects.
Page 14
Disclaimer Carefully inspect all items for damages before accepting delivery. note any damages on the freight bill or express receipt. request name and signature of the carrier’s agent and keep copy to support your claim. Upon acceptance of items, owner assumes responsibility for its safe arrival. Report damages to the carrier and file a claim immediately.
Need help?
Do you have a question about the 168 SERIES and is the answer not in the manual?
Questions and answers