Do you have a question about the Lockbox AES256U3 and is the answer not in the manual?
Questions and answers
Summary of Contents for Silicon Forensics Lockbox AES256U3
Page 1
HARDWARE ENCRYPTED USB3 EXTERNAL HARDRIVE “Lockbox AES256U3” Product Manual & Specifications Contents Product Introduction…………………………………..……………………….…………. 2 System Requirement……………………………………..…………………….…………..2 First Time Use Setup……………….…………………..………………………………….2 Hard Drive Installation and Partitioning- Windows…………………………………………..………………………………………..3-4 Mac………………………………………………..………………………………………..5-6 Resetting Password………………………………………………………………………...7 Frequently Asked Questions (FAQ)………………….……………………………………7 Important Use Notices…………………………….………………………………………..7...
Page 2
“Lockbox AES256U3” Introduction The SiForce “Lockbox AES256U3” (unit) is a large capacity, hardware encrypted storage device with a high speed USB 3.0 interface that can be used with your desktop or notebook computers via a USB port. System Requirements Hardware System USB 3.0 or USB 2.0 jack...
Page 3
“Lockbox AES256U3” Hard Disk Partition – Windows With the BLUE light ON your computer can commutate with the Unit. 1. At this time your computer will not show the unit under “My Computer,” you need to Partition the Unit’s hard disk.
Page 4
A wizard prompting you to set-up the drive should appear. Once you complete the wizard, you can now use your disk! Partitioning the drive is a one-time operation, after you finish you can access the drive with just your password. The next time you just need to input password press “Enter” to access or manage the stored information.
Page 5
Hard Disk Partition – Mac With the BLUE light ON your computer can commutate with the Unit. 3. A prompt should appear saying, “The disk you inserted was not readable by this computer.” 4. Click on the “Initialize” button 5. Follow these steps: Select the “GB Initio SiForce”...
Page 6
Select the desired number of Partitions, desired drive name, and desired file format Once finished, click the “Apply” button, then the “Partition” button to complete the process...
Page 7
Resetting Password 1. Before disconnecting from your computer, press “cancel” and hold for 5 seconds. When the red and yellow lights illuminate and release. 2. Enter the original password and press “enter” key. If the original password is correct, the yellow light will go out and the red light will be flashing.
Need help?
Do you have a question about the Lockbox AES256U3 and is the answer not in the manual?
Questions and answers