Fcc Radio Frequency Statement - Plustek ePhoto Z300 User Manual

Loss of, or damage to, your records or data; or
Economic consequential damages (including lost profits or savings) or incidental
damages, even if we are informed of their possibility.
Some jurisdictions do not allow the exclusion or limitations of incidental or
consequential damages, so the above limitation or exclusion may not apply to you.
This Limited Warranty gives you specific legal rights, and you may also have other
rights that vary from jurisdiction to jurisdiction.
To obtain the warranty service, you may:
contact the authorized dealer or distributor.
visit our website to check out the up-to-date service.
send a request via E-mail for further help.

FCC Radio Frequency Statement

This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular television reception (which can be determined by turning the
equipment off and on), the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from that which the receiver
is connected.
Shielded interconnect cables and shielded power cord which are supplied with this
equipment must be employed with this equipment to ensure compliance with the
pertinent RF emission limits governing this device.
Consult the dealer or an experienced radio/TV technician for help if the conditions
persist.
Changes or modifications not expressly approved by the manufacturer or authorized
service center could void the user's authority to operate this equipment.
20