Using The Product; Inserting/Changing Batteries - LEITZ PRO PRESENTER Instructions For Use Manual

Stylus pen
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Remove the batteries when the product is not being used 
regularly. Otherwise, the batteries may leak. Leaking 
acid can burn skin or damage the product.
Store batteries out of the reach of children and pets. 
Otherwise they could be swallowed by children or pets. If 
swallowed, contact a doctor immediately.
Replace all batteries at the same time. Only use batteries 
of the specified type.
Do not dismantle or short circuit the batteries and keep 
them away from fire. Never attempt to charge non-
rechargeable batteries (danger of explosion!).
Safe use of radio transmitters
The product emits low-powered radio (RF) signals when the 
scroll buttons are pressed. Radio signals can interfere with 
other electronic devices.
Do not use the product in locations where it is forbidden 
to use electronic devices (e. g. in aircraft or hospitals).
Do not use the product near medical equipment. When in 
doubt, ask a doctor.

Using the product

To use the presenter:
1.  Remove the wireless receiver 
2. Slide out the USB connector until it clicks into place.
3.  Plug the wireless receiver into a free USB port on your 
computer. (The computer installs a driver. No further 
steps are required.)
4.  Open the desired application on your computer (e. g. 
PowerPoint
5. Use the scroll buttons 
page. (Equivalent to pressing the page-up/page-down 
keys on the computer keyboard.)
To use the laser pointer: Hold the stylus so that the laser 
outlet 
 is facing away from you. Then press the laser 
A
button 
.
B
To switch between tablet stylus and pen: Just pull out 
the lower part of the stylus. Re-insert it in the desired 
direction. 
To prevent early discharge, remove the batteries when the 
product is not in use.

Inserting/changing batteries

The batteries are not installed when the product is shipped.
1.  To open the battery compartment, unscrew the upper part 
of the stylus.
2. Insert three LR41 coin cell batteries into the battery com-
partment. Pay attention to the polarity (+/–).
3.  Close the battery compartment.
8
).
®
C
 from the stylus.
F
 to move to the previous/next 
EN

Advertisement

Table of Contents
loading

Table of Contents