Troubleshooting - D-Link DIR-610N Quick Installation Manual

TROUBLESHOOTING

SET-UP AND CONFIGURATION PROBLEMS
1. HOW DO I CONFIGURE MY DIR-610N ROUTER FOR A PERSONALIZED
WIRELESS NETWORK NAME (SSID) AND WIRELESS ENCRYPTION KEY?
- Connect your pC to the router using an ethernet cable.
- open a web browser and enter the address http://dlinkrouter or http://192.168.0.1
- the default username is 'admin'. the default password is to leave the field blank.
- if you have changed the password and can not remember it, you will need to reset the router to
set the password back to a blank field.
2. HOW DO I RESET MY DIR-610N TO FACTORY DEFAULT SETTINGS?
- ensure the router is powered on.
- press and hold the reset button on the rear of the device for 10 seconds.
note: Resetting the router to factory default will erase the current configuration settings. to re-
configure your settings, log into the router as outlined in question 1, then run the setup Wizard.
3. HOW DO I ADD A NEW WIRELESS CLIENT OR PC IF I HAVE FORGOTTEN MY
WIRELESS NETWORK NAME (SSID) OR WIRELESS ENCRYPTION KEY?
- every pC that needs to connect to the router wirelessly, you will need to ensure you use the
correct Wireless network name (ssid) and encryption key.
- use the web based user interface (as described in question 1 above) to check or choose your
wireless settings.
- Make sure you write down these settings so that you can enter them into each wirelessly
connected pC. You will find a dedicated area on the back of this document, this important
information for future use.
4. WHY CAN I NOT GET AN INTERNET CONNECTION?
- For cable network users, please log in web based user interface to make sure the MaC Clone
address is set up properly in the internet settings.
- For broadband network users, please log in web based user interface to make sure the user
name and password are correct in the internet settings.
4
DIR-610N