How To Use - Delta Kitchen KS 100 Instruction Manual

How to use

Important: When sharpening a knife for the first time
or if your knife is particularly blunt, proceed as described here in 6.1.
When sharpening a knife, always hold the appliance steady with your left hand and pull the knife
through the sharpening grooves with your right hand.
6.1. Pull the knife through the left and right coarse sharpening grooves
on grinding block 1
the right and left slots for coarse grinding once
6.2. Note that you will need to use both sharpening slots with the same
frequency to achieve a uniform sharpening. Now draw the knife
alternately through the left and right slots for fine sharpening
on grinding block 2
2
4–6 times . Generally, it should be enough to draw the knife through
twice slowly (approx. 4–6 seconds) and then twice quickly
(approx. 1–2 seconds) through each slot. Blunter knives may need
more sharpening (Figure
6.3. To check the level of sharpness, test the knife on appropriate material.
Before continuing to resharpen, clean the knife thoroughly.
6.4. If the desired level of sharpness has not been achieved, draw the knife another 2–3 times
alternately through each of the slots for fine sharpening on grinding block 2
Caution: after sharpening, the blade is razor sharp! To avoid over-
heating, do not exceed the maximum operating time of 2 minutes.
Allow the device to cool down for at least 20 minutes before recommencing.
6.5. Before using the sharpened knife in the household, clean it thoroughly to remove
any residue from the sharpening process, e.g. metal dust or shavings.
Note: Always draw the knife the same amount of times through each of the left and right
slots to ensure an even sharpening.
For a 20 cm blade, each pull through should last approximately 6 seconds.
Shorter knives should be pulled through in 3–4 seconds.
When sharpening, apply slight pressure in the direction of the sharpening discs to ensure
even contact between the blade and the discs during each movement. Additional pressure
is not necessary and will not speed up
the sharpening process.
Avoid cutting into the plastic housing. Accidental nicks in the housing will not affect the
operation of the knife sharpener or damage the blade.
Helpline No:
Web Support:
Model Number:
1
. The knife only needs to be drawn through
2
. Draw the knife through both slots around
C
).
0 808 / 1 01 22 42 (UK)
www.monolith-support.com
KS 100
1 B
(Figure ).
2
1 800 / 65 50 09 (IR)
6
B
1
C
2
.
05