Table of Contents
Advertisement
H
Cleaning the Filter
The Post-Motor Filter is located in the Powerfoot of your vacuum cleaner. It should be
checked often, and cleaned when the Post-Motor Filter becomes dirty.
1.To Clean Post-Motor Filter, remove the screw with a Phillips head screwdriver.
2.Lift out Filter Cover.
3.Remove Post-Motor-Filter and wash with mild soap and water. Dry thoroughly.
4.Reinstall clean and dried Post-Motor filter.
5.Replace Filter Cover by sliding in the two tabs at the top of the Filter Cover and
centering over the screw hole.
6. Replace screw.
Cleaning the Rotating Cleaning
Brush/Replacing the Drive Belt
Check the Rotating Cleaning Brush and Drive Belt regularly for wear or damage. Keep the
Rotating Cleaning Brush ends free of string, hair, and carpet fibers. These can become
entangled and reduce the vacuum's cleaning effectiveness.
NOTE: The Rotating Cleaning Brush can most often be cleaned without removal from the
vacuum. If there is an excessive amount of hair and debris, remove the Rotating Cleaning
Brush for proper cleaning.
1.Unplug the vacuum and turn face down on a flat surface.
2.Remove all 3 screws from the bottom of the Powerfoot.
3.Grip both the Top Cover and base while turning unit back over. Lift off Top Cover.
4.Check Drive Belt. If it is broken or damaged, remove Rotating Cleaning Brush and
replace Drive Belt.
WARNING: To avoid electrical shock or injury from moving parts, always turn OFF the
Power Switch and unplug the Power Source Plug before performing maintenance or trouble
shooting. Always unplug by grasping the Power Source Plug; NEVER pulling on the Power
Cord to unplug.
5.To remove the Rotating Cleaning Brush, pull the right side of the Rotating Cleaning
Brush toward the front of the Powerfoot as you lift slowly.
6.Clean off Rotating Cleaning Brush as necessary.
7.Place existing or new Drive Belt over Rotating Cleaning Brush and the motor shaft. Insert
the end cap pin on the left of the Rotating Cleaning Brush into the slot on the Powerfoot
and slide the end cap pin on the right end of the Rotating Cleaning Brush in to the slot in
the Powerfoot and lower until it clicks into place.
8.Make sure the Furniture Protection Guard is still intact.
9.Align the 3 tabs on the Top Cover with the 3 slots in the Powerfoot. Press into place,
making sure the Furniture Protection Guard is on the outside.
10. Turn vacuum cleaner face down.
11. Reinstall the 3 screws beginning with the center screw.
T
U
Y
OW
O
SE
OUR
D
S
S
UAL
UCTION
V
YSTEM
ACUUM
WARNING: To avoid electrical
shock or injury from moving parts,
always turn OFF the Power Switch
and unplug the Power Source Plug
before performing maintenance or
trouble shooting. Always unplug by
grasping the Power Source Plug;
NEVER pulling on the Power Cord
to unplug.
Advertisement
Table of Contents
