Alfa Romeo Giulia Quadrifoglio 2017 Owner's Manual page 118

Enhanced Accident Response
System
In the event of an impact, if the
communication network remains intact,
and the power remains intact,
depending on the nature of the event,
the ORC will determine whether to have
the Enhanced Accident Response
System perform the following functions:
Cut off fuel to the engine.
Flash hazard lights as long as the
battery has power or until the hazard
light button is pressed. The hazard
lights can be deactivated by pressing
the hazard light button.
Turn on the interior lights, which
remain on as long as the battery has
power or for 15 minutes from the
intervention of the Enhanced Accident
Response System.
Unlock the power door locks.
Turn off the Fuel Pump Heater (if
equipped).
Turn off the HVAC Blower Motor.
Cut off battery power to the:
– Engine
– Electric power steering
– Brake booster
– Electric park brake
116
– Automatic transmission gear
selector
– Horn
– Front wiper
– Headlamp washer pump
Enhanced Accident Response
System Reset Procedure
After the event occurs, when the
system is active, a message regarding
fuel cutoff is displayed. Turn the ignition
switch from ignition AVV/START or
MAR/ACC/ON/RUN to ignition
STOP/OFF/LOCK. Carefully check the
vehicle for fuel leaks in the engine
compartment and on the ground near
the engine compartment and fuel tank
before resetting the system and starting
the engine.
Depending on the nature of the event
the left and right turn signal lights,
located in the instrument panel, may
both be blinking and will continue to
blink. In order to move your vehicle to
the side of the road, you must follow
the system reset procedure.
Customer Action Customer Will See
Note:
Each step MUST BE held for at least
two seconds
1. Turn ignition
STOP/OFF/LOCK.
(Turn Signal Must be
placed in Neutral
State).
Right turn light
2. Turn ignition
BLINKS.
MAR/ACC/ON/RUN.
Left turn light is OFF.
Right turn light is ON
3. Turn right turn SOLID.
signal switch ON. Left turn light
BLINKS.
Right turn light is
4. Place turn signal OFF.
in neutral state. Left turn light
BLINKS.
Right turn light
5. Turn left turn BLINKS.
signal switch ON. Left turn light is ON
SOLID.
Right turn light
6. Place turn signal
BLINKS.
in neutral state.
Left turn light is OFF.
Right turn light is ON
7. Turn right turn SOLID.
signal switch ON. Left turn light
BLINKS.