Firmware Renewal Mode - FUNAI D8A-A4110DB Service Manual

www.freeservicemanuals.info
1. Turn the power on and remove the disc on the tray.
2. To put the DVD player into version up mode, press
[DVD], [9], [8], [7], [6], and [SEARCH MODE]
buttons on the remote control unit in that order.
The tray will open automatically.
Fig. a appears on the screen and Fig. b appears
on the VFD.
" ******* " differs depending on the models.
F/W Version Up Mode
Please insert a DISC
for F/W Version Up.
Fig. a Version Up Mode Screen
Fig. b VFD in Version Up Mode
The DVD player can also enter the version up
mode with the tray open. In this case, Fig. a will be
shown on the screen while the tray is open.
3. Load the disc for version up.
4. The DVD player enters the F/W version up mode
automatically. Fig. c appears on the screen and
Fig. d appears on the VFD. If you enter the F/W for
different models, "Disc Error" will appear on the
screen, then the tray will open automatically.
" ******* " differs depending on the models.
F/W Version Up Mode
VERSION :
Reading...
(*1)
Fig. c Programming Mode Screen
Fig. d VFD in Programming Mode (Example)
The appearance shown in (*1) of Fig. c is
described as follows:
No. Appearance
1 Reading...
2 Erasing...
3 Programming... Writing new version data

FIRMWARE RENEWAL MODE

Model No : *******
VERSION : *.**
EXIT: POWER
Model No : *******
VERSION : *.**
************.***
State
Sending files into the memory
Erasing previous version data
World of free manuals
5. After programming is finished, the tray opens
automatically. Fig. e appears on the screen and
the checksum in (*2) of Fig. e appears on the VFD
(Fig. f).
" ******* " differs depending on the models.
F/W Version Up Mode
VERSION :
Completed
SUM : 7ABC
Fig. e Completed Program Mode Screen
Fig. f VFD upon Finishing the Programming Mode (Example)
At this time, no button is available.
6. Remove the disc on the tray.
7. Unplug the AC cord from the AC outlet. Then plug
it again.
8. Turn the power on by pressing the [STANDBY-ON]
button and the tray will close.
9. Press [DVD], [1], [2], [3], [4], and [DISPLAY]
buttons on the remote control unit in that order.
Fig. g appears on the screen.
" ******* " differs depending on the models.
MODEL : *******
Version : *.**
Region : *
EEPROM CLEAR : CLEAR
1-9-1
Model No : *******
VERSION : *.**
************.ab7
EXIT: POWER
Fig. g
E8B00FW
26/5/2013