Yamaha MC802 Operating Manual page 5

" AUX Controls (1,2 & 31
The MC-series mixing consoles have three independent AUX busses which are fed by the
corresponding AUX controls on the input channels_ Each AUX control determines the level of
the signal sent from that channel to the correspondingly numbered AUX mixing buss, which in
tum feeds the correspondingly numbered AUX SEND control and AUX SEND jack on the
console's rear panel. The AUX controls can be used to determine the amount of signal from the
corresponding input channel sent to external effect devices or power amps fed by the AUX
SEND jacks_
• AUX 1 is factory pre-wired for pre-EO/pre-fader operation, so the AUX 1 signal is not
affected by the setting of the channel EO controls or fader_ An internal jumper allows the
AUX 1 control to be rewired for post-EO/post-fader operation _
* AUX 2 and AUX 3 are factory pre-wired for post-EO/post-fader operation, so the AUX 2
and AUX 3 signals are affected by the setting of the channel EO controls and fader _ Internal
jumpers aI/ow the AUX 1 control to be rewired for pre-EO/pre-fader operation_
• An internal POST EO jumper allows the AUX controls to be' further re-configured for
post-EO/pre-fader operation _
• REFER THE ABOVE-MENTIONED REWIRING JOBS TO OUALIFIED YAMAHA SER ­
VICE PERSONNEL!
o
PAN Pots
The PAN pot determines the position in the stereo sound field at which the sound from that
channel is heard_ Rotated fully counterclockwise the channel signal will be delivered from the
left stereo output only, and will be heard at the far left of the sound field_ If the PAN pot is
turned fully clockwise, the sound from that channel will appear at the far right of the stereo
sound field. I f the PAN pot is set at its center position, the channel signal will be sent equally
to both the left and right channels, causing the sound to appear at the center of the sound field_
I ntermediate PAN pot settings cause the sound to be heard at the corresponding position,
8
CUE Switch
When the CUE switch is pressed, the pre-EO/pre-fader signal from that channel is fed to the
PHONES output via the CUE/PHONES level cOrltrol. The channel cue signal will be added to
any other active cue signal. If you want to monitor only the signal from a single channel, make
sure all other CUE switches are turned OFF_
4