Cleaning The Appliance; Tips For Saving Energy; Operating Noises - Bosch KSW Operating Instructions Manual

Cleaning the appliance

1. Attention: Pull out the mains plug
or switch off the fuse!
2. Wipe the door seal with clear water only
and then wipe dry thoroughly.
3. Clean the appliance with lukewarm
water and a little washing up liquid.
Water must not get into the control
panel.
4. After cleaning: reconnect and switch
on the appliance.
Do not use abrasive or acidic cleaning
agents and solvents.
Regularly clean the condensation channel
and drainage hole, Fig. 6, so that the
condensation can flow out. Clean the
condensation channel with cotton buds,
etc.
Water used for cleaning must not
run through the drainage hole into the
evaporation pan.
Active carbon filters
Fig. 7
The activated carbon filter, ensures that
air is replaced and odours reduced in the
appliance.
We recommend replacing the filter
annually.
Replacement filters are available from
customer service.

Tips for saving energy

S Install the appliance in a dry, well
ventilated room, but not in direct
sunlight and not near a heat source
(e.g. radiator, cooker, etc.). If required,
use an insulating plate.
S Open and close the door as briefly
as possible.
S Occasionally clean the rear of the
appliance with a vacuum cleaner or
paint brush to prevent an increased
power consumption.

Operating noises

Completely normal noises
Humming noise - refrigerating unit is
running.
Bubbling, whirring or gurgling noises -
refrigerant is flowing through the
refrigeration tubing.
Clicking noise - motor is switching on or
off.
en
23