Related Manuals for hestan GIMR15
Summary of Contents for hestan GIMR15
- Page 1 Outdoor Ice Machine Installation and Instruction Manual GIMR15 15” OUTDOOR ICE MACHINE RIGHT HINGE GIML15 15” OUTDOOR ICE MACHINE LEFT HINGE P/N 011026 rev B...
- Page 2 Should the reader have any questions or concerns which have not been satisfactorily addressed, please call, send an e-mail message, or write to the Hestan Technical Support Department for assistance. Phone: 1-888-905-7463 E-mail: outdoorwarranty@hestan.com...
-
Page 3: Table Of Contents
IMPORTANT This manual should be read carefully before the ice machine is installed and operated. Read the warnings and guidelines contained in this booklet carefully as they provide essential information for the continued safe use and maintenance of the ice machine. Retain this booklet for any further reference that may be necessary. -
Page 4: Important Safety Information
Important Safety Information Throughout this manual, notices appear to bring your attention to situations which could result in death, serious injury, damage to the appliance, or damage to property. WARNING Indicates a hazardous situation which could result in death or serious injury. - Page 5 WARNING, continued • This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
-
Page 6: Specifications
I. Specifications A. Construction Top Panel Ice Making Mechanism Bin Control Thermostat Bulb Scoop Holder Slope Magnet Catch Front Panel Control Switch Door Power Cord Louver... -
Page 7: Electrical Data
B. Electrical Data HESTAN ICE MACHINE MODEL NUMBER GIM_15 SERIAL NUMBER AC SUPPLY VOLTAGE 115-120/60/1 AMPERES 3.8 AMPS DESIGN PRESSURE HI-240PSI LO-120PSI REFRIGERANT 134a 4.2 OZ. Note: In the "MODEL NUMBER" the _ references either a (L) Left or (R) Right hinge model See the nameplate for electrical and refrigeration specifications. -
Page 8: Dimensions/Connections
C. Dimensions/Connections GIM_15... -
Page 9: Installation Instructions
II. Installation Instructions WARNING • This ice machine must be installed in accordance with applicable national, state, and local codes and regulations. • CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are securely in place after installation. Make sure that none have fallen into the storage bin. -
Page 10: Built-In Installation Site
2. Built-In Installation Site NOTICE • Do not let the weight of the counter rest on the ice machine. • Do not install the ice machine in a corner where the door will interfere with other equipment or where the ice machine cannot be pulled out for service. Installation Space Model Height... -
Page 11: Setup
C. Setup 1) Position the ice machine in the selected permanent location. 2) Level the ice machine from side-to-side and front-to-rear by adjusting the feet. D. Electrical Connection WARNING • Electrical connection must meet national, state, and local electrical code requirements. -
Page 12: Water Supply And Drain Connections
• In areas where water damage is a concern, install in a contained area with a floor drain. • Water line installation to the ice machine is not warranted by Hestan. • Water-hammer issues must be resolved by a qualified plumber before installing the ice machine. -
Page 13: Final Checklist
• A water supply line shut-off valve and drain valve must be installed. A minimum of 1/4" nominal ID copper water tubing or equivalent is required for the water supply line. Be sure there is sufficient extra water supply line for the unit to be pulled out for service. •... -
Page 14: Operating Instructions
• This ice machine must be maintained in accordance with the instruction manual and labels provided with the ice machine. Consult with your local Hestan Certified Service Representative about maintenance service. • This ice machine must be cleaned and sanitized at least once a year. More frequent cleaning and sanitizing may be required in some water conditions. -
Page 15: Startup
NOTICE • Protect the floor when moving the ice machine to prevent damage to the floor. • If using the optional drain pump (AGDP), test its operation every time the ice machine is cleaned and sanitized. See "IV.E. Optional Drain Pump AGDP" for details. - Page 16 4) Move the control switch to the "ICE" position and allow the ice machine to operate for 2 minutes. This allows the water tank to fill. 5) Move the control switch to the "OFF" position. 6) Inside the storage bin, disconnect the suction tube by squeezing the tabs and pulling the tube clear.
-
Page 17: Maintenance
IV. Maintenance This ice machine must be maintained in accordance with the instruction manual and labels provided with the ice machine. Consult with your local Hestan Certified Service Representative about maintenance service. WARNING • Only qualified service technicians should service this ice machine. -
Page 18: Cleaning And Sanitizing Instructions
B. Cleaning and Sanitizing Instructions This ice machine must be cleaned and sanitized at least once a year. More frequent cleaning and sanitizing may be required in some water conditions. WARNING • To prevent injury to individuals and damage to the ice machine, do not use ammonia type cleaners. - Page 19 6) Move the control switch to the "WASH" position. 7) Allow the cleaning solution to circulate for 30 minutes, then move the control switch to the "OFF" position. 8) Disconnect the suction tube. Allow the water tank to drain, then reconnect the suction tube.
- Page 20 4) Disconnect the suction tube. Allow the water tank to drain. 5) Spread out the tabs to unlock the water tank, then slide it out. See Fig. 38. 6) Lift off the ice chute from the front frame pipe and then from the rear frame pipe. See Fig.
- Page 21 13) Position and lock the ice chute onto the front and rear frame pipes by pushing the ice chute down until it clicks onto both frame pipes. See Fig. 44. 14) Slide in the water tank along the rails at the bottom of the left and right brackets until it locks into place.
-
Page 22: Storage Bin Drain
29) Clean the storage bin liner, door liner, and door gasket with a neutral cleaner. Rinse thoroughly after cleaning. 30) Move the control switch to the "ICE" position to start the automatic icemaking process. C. Storage Bin Drain In some conditions, slime may build up inside the storage bin drain and prevent water from draining properly. -
Page 23: Condenser
D. Condenser Check the condenser once a year, and clean if required by following the steps below. More frequent cleaning may be required depending on location. WARNING • Move the control switch to the "OFF" position and unplug the ice machine from the electrical outlet before cleaning the condenser. - Page 24 5) If water pumps out properly and the drain pump then de-energizes, proceed to step 6. If water does not pump out properly and/or the drain pump does not de-energize, the appliance must be serviced by a qualified service technician before proceeding. 6) Move the control switch to the "ICE"...
-
Page 25: Preparing The Ice Machine For Periods Of Non-Use
V. Preparing the Ice machine for Periods of Non-Use During extended periods of non-use, extended absences, or in sub-freezing temperatures, follow the instructions below. When the ice machine is not used for two or three days under normal conditions, it is sufficient to move the control switch to the "OFF" position. - Page 26 Hestan Commercial 3375 E.La Palma Ave Anahheim, CA 92806 888-905-7463 P/N 011026 rev B...
Need help?
Do you have a question about the GIMR15 and is the answer not in the manual?
Questions and answers