1. Manuals
  2. Brands
  3. Brigade Manuals
  4. Ventilation Hood
  5. 3 SERIES
  6. Installation manual

Brigade 3 SERIES Installation Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Installation
3 Series
Hoods
RVCH330 / CRVCH330

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 3 SERIES and is the answer not in the manual?

Questions and answers

Related Manuals for Brigade 3 SERIES

Summary of Contents for Brigade 3 SERIES

  • Page 1 Installation 3 Series Hoods RVCH330 / CRVCH330...

  • Page 2: Table Of Contents

    Table of Contents Warnings & Important Information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 RVCH Classic Chimney Wall Hoods w/Standard Ventilator Dimensions &...
  • Page 3 IMPORTANT– Please Read and Follow! NOTE: If installing hood with warming shelf panel, W A R N I N G install warming shelf panel first. TO REDUCE THE RISK OF FIRE, ELECTRICAL IMPORTANT – PLEASE READ AND FOLLOW SHOCK, OR INJURY TO PERSONS, OBSERVE •...
  • Page 4 IMPORTANT– Please Read and Follow! W A R N I N G W A R N I N G TO REDUCE THE RISK OF INJURY TO TO REDUCE THE RISK OF PERSONS IN THE EVENT OF A RANGETOP FIRE, ELECTRICAL SHOCK, GREASE FIRE, OBSERVE THE OR INJURY TO PERSONS FOLLOWING.

  • Page 5: Rvch Classic Chimney Wall Hoods W/Standard Ventilator

    Dimensions & Specifications (RVCH Classic Chimney Wall Hoods w/Standard Ventilator) ” ( 4 0 ” ( 3 0 2 ” ( 5 . ( 3 0 ” ( 7 6 ” ( 3 0 ” ” A (Hood width) ( 6 1 30”W.

  • Page 6: Clearance Dimensions

    Clearance Dimensions (RVCH Classic Chimney Wall Hoods w/Standard Ventilator) ” m ” m ( 1 6 i n . ( 7 6 7 . 6 i n . ” m ” m ( 1 7 ( 8 3 5 . 3 ”...

  • Page 7: Interior Ventilator Dimensions

    Interior Ventilator Dimensions (RVCH Classic Chimney Wall Hoods w/Standard Ventilator) Top view 16” (40.6 cm) 4” 30”W. 14-15/16” (37.9 cm) (10.2 cm) 9-3/4” 36”W. 17-15/16” (45.6 cm) (24.8 cm) 120 V 7” (17.8 cm) dia. duct location 460 CFM Interior Ventilator Installation...

  • Page 8: Planning Information

    Planning Information Plan where the duct work will be located. Install 300 or 600 CFM proper-sized duct work, roof, or wall cap for the Roof cap single blower interior-power type of blower you are using. Adjust your 7” round duct typical ductwork measurements for various heights of ceilings, soffits, cabinets, or ranges/rangetops.

  • Page 9: Installation (Rvch Classic Chimney Wall Hoods W/Standard Ventilator)

    Installation (RVCH Classic Chimney Wall Hoods w/Standard Ventilator) Check damper for unrestricted movement, Attach transition to damper. Seal with aluminum tape. adjust if necessary. W A R N I N G TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING •...
  • Page 10 CAUTION: If not using a duct cover, using CAUTION: Secure vent hood to wall using screws provided. Use additional mounting screws and screws provided make sure top mounting screws are secured into soffit or cabinet frame. Use additional wall anchors, if necessary. mounting screws, if necessary.

  • Page 11: Duct Cover (Rvch Classic Chimney Wall Hoods W/Standard Ventilator)

    Slide filter front over front lip. Push filter rear up, then slide back over rear lip. Duct Cover (RVCH Classic Chimney Wall Hoods w/Standard Ventilator) Measure distance from ceiling to canopy. Tape to avoid scratching. Place duct cover top inside duct cover base and lower until Slide duct cover in place and fasten from inside desired height is found.

  • Page 12: Installation (Rvch Classic Chimney Wall Hoods W/Recirculating Kit)

    Installation (RVCH Classic Chimney Wall Hoods w/Recirculating Kit) Remove damper and discard with transition. Turn recirculating unit upside down. Place vent hood upside down on recirculating unit. Attach with screws. Attach with screws and lock washers provided. W A R N I N G TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING...
  • Page 13 Flip hood over. Insert 6” of electrical wiring through CAUTION: Secure vent hood. Make sure mounting the top of vent hood and secure using wiring restrain. screws are secured into framing using additional Refer to local codes. mounting screws and wall anchors, if necessary. BARE OR GREEN GREEN BLACK...
  • Page 14 Slide spacer front over front lip. Push spacer rear up, Slide filter front over front lip. Push filter rear up, then slide back over rear lip. then slide back over rear lip.

  • Page 15: Service & Registration

    Service & Registration If service is required, call your authorized service agency. Have the following information readily available. • Model number • Serial number • Date purchased • Name of dealer from whom purchased Clearly describe the problem that you are having. If you are unable to obtain the name of an authorized service agency, or if you continue to have service problems, contact Viking Range at 1-888-845-4641, or write to: VIKING RANGE, LLC...
  • Page 16 Viking Range, LLC 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-845-4641 or visit our website at vikingrange.com in the US or brigade.ca in Canada (090115) F21205B EN...

This manual is also suitable for:

Rvch330Crvch330

Table of Contents