OVERVIEW The ROK:X Salt Chlorinator is part of a range of intensively researched, high quality, connected products that work in harmony to ensure the pool is easy to maintain and ready for use at any time.
Page 4
INSTALLATION 1. Mount the Power Pack well above the ground and above the Cell if possible to prevent water from entering the Power Pack or Junction Box when the cell is removed for cleaning. Saltwater will burn/damage the Junction Box and damage electrical components in the Power Pack.
Page 5
DIAGRAM Power Pack Power Pack Make sure that screws are (Ensure Good Ventilation) tight on wires and colours match. ROK-X20 NORIA performance on demand Red: Closet to Front CELL White: Centre AUTO Black: Closet to Rear MANUAL SOFT focus WATER...
OPERATION 1. Connect the equipment as explained in installation section. 2. Turn the chlorine production control to maximum and switch the unit on. If the salt level is correct the output should be close to 100% (at the top of the green or just into the red). When the water is cold it will read slightly lower than when warmer.
CELL CLEANING 1. The Cell should not normally require cleaning. 2. In very hard water all calcium may not be removed. A slight deposit might form on the legs, sensor or sides of the cell plates. This will NOT effect the operation. 3.
TROUBLESHOOTING Excessive Calcium Build Up on Cell (even after cleaning) 1. The current should reverse every 4-6 hours. This can be tested by switching off the Cell switch while it is running and turning it on after 20 seconds (not less). The Cell current should now be in the opposite direction.
Page 9
Nil Chlorine Production: 1. Check fuse/Circuit Breaker. 2. Check that the Pump is running and water is flowing through the Cell. 3. Check that the Sensor Peg is covered with water and not air/bubbles. 4. Check that the sensor is not covered with Calcium. 5.
Page 11
Noria equipment works in harmony ensuring pools and spas are easy to maintain and ready for use at any time. All Noria equipment comes with extensive warranties backed by the service and support of Focus Products – an Australian owned company delivering the complete partnership solution to pool and spa industry.
WARRANTY THIS EQUIPMENT HAS BEEN MANUFACTURED AND TESTED TO THE HIGHEST STANDARD AND ACCORDINGLY CARRIES THE FOLLOWING WARRANTY. 1. The Power Pack will be repaired or replaced at no charge for a period of 24 Months from the date of purchase should it be found, after examination, that the failure has been caused by faulty workmanship or materials.
Page 13
7. The maximum liability incurred by the manufacturer shall not in any case exceed the contract price for the equipment or the product parts or components thereof claimed to be defective. Further, the manufacturer shall not be liable for any loss, damage or delay directly or indirectly caused by any malfunction of or defect of or failure of the equipment other than as expressly provided in this warranty.
Page 15
PO Box 131 Carole Park QLD4300 Name ______________________ Address ______________________ ______________________ ______________________ Suburb ______________________ Postcode ______________________ Purchased From ______________________ Date Purchased ______________________ Installation Date ______________________ Model o ROK:X Serial Number ______________________ Signature ______________________ OFFICE USE ONLY RECEIVED ______/________/_______ RECEIVED BY _______________________ WARRANTY# _______________________...
Page 16
A PERFORMANCE PRODUCT BY 1300 1 FOCUS 1300 1 36287 focus 1300 2 36287 35 Moreton Street HEATHWOOD Q 4110 PRODUCTS PTY LTD PO Box 131 www.focusproducts.com.au CAROLE PARK Q 4300 noria@focusproducts.com.au CHEMICALS • EQUIPMENT • PVC • SUPPORT...