Advertisement
I.
Power pilot LED
J.
AC85V~265V Power Cord
K.
DC 12V or AC24V/DC 12V Block Terminal
L.
DC 12V power input terminal
3.1 Auto Iris Lens Connector
●
Use the accompanying auto iris lens control connector plug.
For auto iris lens with built-in EE amp.（VIDEO Type）
Set the lens selector switch to "Video" position.
Connector cable leads
1.Red----power
3.White----video 4.Black----shielded
For auto iris lens without EE amp.（DC Type）
This is the view from external of camera
Set the lens selector switch to "DC" position.
Connector cable leads
1.Damping coil（－） 2.Dampling coil（＋）
3.Driving coil（＋）
Connect the leads as shown above; refer to the instructions of the lens.
3.2 Power Terminal
3.2.1 DC 12V SST-6420 model
Connect the power supply to the power-input terminal as shown is the
figure right
1.Power for the camera is 12VCD±10％, connector "DC 12V" as
and the "G" is common ground.
2.Vψ terminal for external Vertical phase input as Line lock
3.Connector's center as positive and the outside being common ground.
3.2.2 AC 24V/DC 12V SST-6420D model
This terminal accepts both AC 24V and DC 12V non-polarity
3.2.3 AC 85V~265V SST-6420P model
This camera equipped with a universal switching power supply, it can accept
power source input from 85VAC to 265VAC
2.NC
4.Driving coil（－）
D C 12 V
-3 -
1
3
2
4
positive
Advertisement
