Advanced Settings - AUTO SKEW SNIPE 2 User Manual

5. Advanced Settings

Modify Transponder (TP) mode
i. Press MODE twice to enter "Modify TP mode" and press OK.
NOTE
To select and set numbers, use arrow buttons to see available options. The numbers adjust individually with the
cursor and press OK to move to next option. This function is only used if the satellite operator changes all its
parameters.
ii. Select the satellite to be modified, as example "00 XXXX(satellite name) ~ 11 XXXX" and press OK..
iii. Select TP number among "00~02" and press OK. (Three TP's are programmed for each satellite)
iv. Repeat the same process by inputting data for FREQ (frequency) and SYMBOL (symbol rate).
v. Select type of signal DVBS or DVBS2 and press OK.
vi. Select polarization VER (vertical) or HOR (horizontal) and press OK.
vii. Select YES or NO to save and/or go back to first stage of TP Modify.
viii. To exit, press MODE and the unit will return to previous status.
ix. For manual TP data RESET, press SET and select YES and then press OK.
Restart the unit to apply the reset to your next start up.
ENGLISH - 11