Table of Contents
Advertisement
Quick Links
Entrance Dynamics sliding door operator
EDSL450
User manual
Original instructions
© All rights in and to this material are the sole property of Entrance Dynamics BV. Copying, scanning,
alterations or modifications are expressly forbidden without the prior written consent of Entrance
Dynamics BV. Rights reserved for changes without prior notice.
Advertisement
Table of Contents
Summary of Contents for Entrance Dynamics BV EDSL450
- Page 1 User manual Original instructions © All rights in and to this material are the sole property of Entrance Dynamics BV. Copying, scanning, alterations or modifications are expressly forbidden without the prior written consent of Entrance Dynamics BV. Rights reserved for changes without prior notice.
-
Page 2: Table Of Contents
EDSL450 User manual Table of contents Revision information: ..........................4 About this manual ........................... 5 Maintenance of your sliding door ......................5 Dismantling and disposal of the door operator .................. 5 Your local service provider ........................5 Door leaf - Scope of delivery ......................5 Introduction ............................. - Page 3 EDSL450 User manual 4.3.1 Clean the door ....................... 15 Troubleshooting ..........................16 Checklist before you contact your local service provider ............. 16 Declaration of incorporation ......................17...
-
Page 4: Revision Information
EDSL450 User manual Revision information: Date: Revision: Description: 21-08-2014 1.00 Initial publication 01-12-2014 1.10 Changed declaration... -
Page 5: About This Manual
EDSL450 User manual About this manual All users and owners of the EDSL450 sliding door must read, understand, and abbey the information and instructions in this manual. Failure to do so may result in damage to, or failure of the equipment, and possibly injury to persons. -
Page 6: Introduction
EDSL450 User manual 1 Introduction The sliding door is designed to enable easy access to and from buildings or between building sections. The sliding door has 3 primary parts: Door leaves Drive unit Activators / Safety sensors 1.1 Door Leaves The door leaves are usually made of glass and surrounded by profiles made of aluminium. -
Page 7: Motor
EDSL450 User manual 1.2.1 Motor The motor, which is part of the drive unit, drives the door leaves through a tooth belt. The motor operates on 40V DC. 1.2.2 Control board EDSL-CU-450 The control board EDSL-CU 450 is the central controller for the sliding door. It receives information from the safety devices and motion detectors and operates the motor to open or close the door. -
Page 8: Program Selector Switch
EDSL450 User manual 1.5 Program selector switch The Program switch is used to select the required program. The program switch can be installed close to the door or at another location in the building. 1.6 Program selection and interaction The program switch is used to select the program that will be used for the sliding door. -
Page 9: Program Indication
EDSL450 User manual Program change may not be possible if the program is overridden in the door controller. For added security the key can be removed from the switch when positioned in any position, except the reset position (F). 1.7.1 Program indication The active program of the door controller is presented with an indicator. -
Page 10: Reset Error
EDSL450 User manual Multiple warnings can be active simultaneously. However, only one warning will be shown. The door controller determines what code will be shown. 1.7.5 Reset error To reset the error, the reset position must be selected for more than 1 second. On selecting a program position the reset command is transmitted. - Page 11 EDSL450 User manual 1.7.7.2 Table Error codes F Error description Supply failure Current offset error Temperature error Motor drive fault Motor inverted while operational Connect motor Motor shorted Motor and/or encoder Encoder error Low home current Escape motor movement direction...
-
Page 12: Safety
EDSL450 User manual 2 Safety 2.1 Safety symbols used in this manual The following safety symbols are used in this manual: Indicates a general warning Only authorized persons are permitted to operate the door. • Read and fully understand the safety instructions before you operate or do maintenance on •... -
Page 13: Operating Instructions
EDSL450 User manual 3 Operating instructions 3.1 Daily Procedures 3.1.1 Daily start procedure Visually check the door for damage • If damage is found: • o Apply suitable warning signs around the door and on the door leaves. o Contact your local service provider. -
Page 14: Maintenance
EDSL450 User manual 4 Maintenance According to the EN16005, DIN18650, and AutSchR for escape routes, the installer retains responsibility for the safe operation of the sliding door, only when user instructions are obeyed and the service checklist and scheduled maintenance tasks are done by authorised/certified people. If not, the owner takes over all responsibility. -
Page 15: Preventive Maintenance Procedures
EDSL450 User manual Frequency Tasks Every 4 years or 500.000 openings Replace the carriage wheels Replace the wheel track Replace the anti-derailment wheels Every 7 years or 750.000 openings Replace the drive unit Replace the electric lock The economic life time of the products is on normal use and in a normal environment, estimated on 10 years or 1.000.000 cycles,... -
Page 16: Troubleshooting
EDSL450 User manual 5 Troubleshooting This chapter contains troubleshooting information for the user of an automatic sliding door. If a fault is not described below, contact your local service provider for assistance. Symptom Cause Solution Door does not No power Make sure the main switch/and fuse are open. -
Page 17: Declaration Of Incorporation
Breeuwhamer 6 1648 HG De Goorn Netherlands Declare under our sole responsibility that the type of equipment: Sliding door operator type EDSL450 Sliding door retrofit kit type EDSL450 Is in compliance with the following directives: 2006/95/EC Low Voltage Directive 2004/108/EC...
Need help?
Do you have a question about the EDSL450 and is the answer not in the manual?
Questions and answers