Table of Contents
Advertisement
PSQW2304A.fm Page 9 Wednesday, May 13, 2009 3:38 PM
Location of Controls
PROGRAM: Used to enter and exit the
1
programming mode.
CONF (Conference): Used to establish a
2
multiple party conversation.
INTERCOM: Used to make or receive
3
intercom calls.
FWD/DND (Call Forwarding/Do Not
4
Disturb): Used to perform Call Forwarding
or Do Not Disturb.
FLASH/RECALL: Used to disconnect the
5
current call and make another call without
hanging up.
AUTO ANS (Auto Answer): Used to
6
receive an incoming call in the hands-free
mode.
MUTE: Used to mute the microphone
during a conversation.
AUTO DIAL/STORE: Used for speed
7
dialling or storing program changes.
TRANSFER: Used to transfer a call to
8
another party.
REDIAL: Used to redial.
9
HOLD: Used to place a call on hold.
10
SP-PHONE (Speaker Phone): Used for
11
the handsfree operation.
Navigator Key: Used to adjust the volume
12
and the display contrast or select desired
items for each function.
Programmable Feature (PF) Button:
13
Used as an One-touch Dialling button
(Button assignment is required).
Flexible Outside (CO) Line Button:
14
Used to make or receive an outside call.
Pressing this button seizes an idle outside
line automatically. (Button assignment is
required.) Also used as the desired
function buttons. (Button assignment is
required.)
PAUSE: Used to insert a pause during
15
dialling.
MESSAGE: Used to leave a message
16
waiting indication or call back the party
who left the message waiting indication.
Message/Ringer Lamp: The Message/
17
Ringer lamp informs you visually that you
have a message or a call.
When you receive a call, the lamp
flashes depending on the ringing pattern.
When someone has left you a message,
the lamp is lit continuously.
When the ringing pattern is set to Single
(Slow flash), Double (Moderate flash), or
Triple (Rapid flash) in your PABX, the
lamp flashes. When the other ringing
patterns are set in your PABX, the lamp
may not flash (e.g., S-Double, Call
Waiting Tone1).
– 9 –
Advertisement
Table of Contents
