Table of Contents
Summary of Contents for Mermaid CONDENSATOR
-
Page 1: Troubleshooting
MERMAID CONDENSATOR™ INSTALLATION MAINTENANCE & TROUBLESHOOTING GUIDELINES Mermaid Manufacturing of Southwest Florida, Inc. 2651 Park Windsor Drive, Suite 203 Fort Myers, Fl 33901 Phone: 800 330-3553 Fax: 239 418-0538 E-mail: info@mmair.com Web Site: http://www.mmair.com... - Page 2 THIS CONDENSATOR MUST BE INSTALLED ABOVE THE WATER LINE OR FLOODING MAY OCCUR First review the contents of the Mermaid Condensator™ kit, insuring you recognize all the parts. We suggest you read the complete installation instructions before you start. The next thing to do is to go to your circuit breaker panel and switch your air conditioner...
- Page 3 Condensator. Water flow must be towards the thru-hull discharge. Slide two of the large stainless steel hose clamps onto each side of the cut hose ends. The Condensator will not work if installed with the arrow in the direction back to the air conditioning unit.
- Page 4 This valve is the check valve for the device. It is located between the Condensator and the Shurflo filter. This device needs to be kept in line. This is a backflow preventative device and should not be tampered with.
- Page 5 If you continue to have problems with the Condensator, then it is likely a result of a blockage in the water line. The first item to check is your water strainer. Inspect the mesh screen to insure that it is in tact and seated properly. It is assumed you are cleaning your water strainer on a regular basis.
- Page 6 Condensator is working properly, that you have reassembled the check valve assembly correctly, and that the Condensator is not allowing water to backflow to the condensation pan. Go to your daytimer or calendar, and go forward and mark the point where you will...
- Page 7 The condensator works off the flow of water through the air conditioner. When the air conditioner is turned off, this flow stops and condensation is not drained from the tray.
Need help?
Do you have a question about the CONDENSATOR and is the answer not in the manual?
Questions and answers