Table of Contents
Advertisement
Seat
The
Aztec
has
an
ergonomically
designed,
high
back
self-draining
weatherproof seat with angle adjustable
flip up armrests.
To
adjust
the
seat
forwards
and
backwards move lever under left edge
of seat outwards and hold while sliding
seat to desired position.
Note: Do not attempt to adjust the seat
while vehicle is in motion.
Seat Removal
To remove seat, depending on the
model, undo and remove the hand-
wheel under front edge of the seat. Lift
front of seat about 45 degrees or until
the locating hooks clear, once lifted, pull
seat forward and up.
To replace seat, tilt seat with back of
plate down into hooks mounted on
vehicle, lower seat until horizontal then
insert and do up the hand-wheel under
front edge of seat.
Battery Access
To access the batteries, first tip up and
remove the seat. The batteries are
clamped into the scooter by a hand-
wheel holding down a metal bar. Once
the bar is removed you can move and
lift out the batteries as required. To do
this, first undo the battery terminals,
taking extreme care not to touch any
two terminals together as this will cause
injury such as severe burns and/or
permanent damage to the vehicle or
batteries may occur. The lead across
the two front terminals that contains the
80A Main Battery fuse should be
removed first, followed by the two rear
terminals.
When
reconnecting
the
batteries, ensure the correct wires go to
the correct terminals.
6
Advertisement
Table of Contents
