Do you have a question about the TK303 and is the answer not in the manual?
Questions and answers
Summary of Contents for Guangzhou Cylink TK303
Page 1
TK303 GSM/GPRS/GPS Tracker User Manual Preface Thank you for purchasing the tracker. This manual shows how to operate the device smoothly and correctly. Make sure to read this manual carefully before using this product. Please note that specification and information are subject to changes without prior notice in this manual. Any change will be integrated in the latest release.
Page 3
6.27.7. Movement alarm........................16 6.27.8. Overspeed alarm........................16 6.27.9. Fuel Alarm..........................17 6.28. Alarms under Arm State........................17 6.28.1. Door Open Alarm........................17 6.28.2. ACC Alarm..........................17 6.28.3. Built in Acceleration Sensor Alarm...................17 6.28.4. Alarm without GSM network service..................18 6.29. Sleep Mode............................18 6.29.1.
1. Summary 1.1 Working Based on existing GSM/GPRS network and GPS satellites, Set multiple functions of security, tracking, monitoring surveillance, emergency alarms and management,this product can locate and monitor any remote targets by SMS or internet. 1.2 Features 1.2.1 Built-in GSM, GPS antenna, compact, elegant appearance. 1.2.2 Support GPS and LBS (Location based service) double tracking solutions.
4. Accessories Applicable Photo Name Specifications model Harness 12PIN Standard Microphone 1.5m Standard 12V/40A or Relay Standard 24V/40A siren 12V/24V Optional Fuel sensor Optional Remote Optional for control type G...
5. Specifications Content Specification 9.6×5.3×1.6cm Weight Network GSM/GPRS Band 850/900/1800/1900Mhz GPS sensitivity -159dBm GPS accuracy Cold status 45s GPS start time Warm status 35s Hot status 1s Car power 12 V -24V supply Back up battery Chargeable 3.7V 700mAh Li-ion battery Storage Temp -40°C to +85°C Operation...
Wiring diagram 6.1.5 Note: The pink wire can be connected to the original car horn; it can also be connected to the siren bought with the tracker. 6.1.6 Know about the type of the door trigger is positive or negative trigger. Please connect the green wire to the door control circuit if it is positive, and connect blue wire if it is negative.
Blue LED: In good GPS reception, LED quick flash for each second, No GPS reception, LED OFF. 6.5. Initialization Send SMS “begin+password” to the unit, it will reply “begin ok” and initialize all the settings to default factory settings.(default password: 123456) For example: send SMS “begin123456”, it will reply “begin ok”.
6.8.2. If you call it from authorized phone number, it will hang up and report a real-time location as below: When lost fix to satellites, it will track by LBS / CELL-ID. And the SMS will include two positions: GPS coordinates of the last known position. ...
6.10.2 Send "angle+password+space+angle" to tracker, it will reply" angle ok". e.g. angle123456 6.10.3 The angle must be 3 digits Arabic numbers, default angle value is 30 degree. 6.11. GPS drift suppression 6.11.1 This function is deactivated by default, send "suppress+password" to tracker, it will reply" suppress drift ok".
6.14.2 Send SMS “monitor+password” to the unit, and it will reply “monitor ok!” and switch to “monitor” mode. 6.14.3 Send SMS “tracker+password” to the unit, and it will reply “tracker ok!” and switch to “track” mode. 6.15. Data logging 6.15.1 Auto logging:When the tracker device lost GSM signals or fall offline from GPRS, tracker will log the tracking position and alerts automatically in the SD card on the basis of the pre-set condition, when GSM signals get back, all the event alerts will be auto-sent to the authorized numbers or web platform (server), but the logged tracking data should be loaded to the web platform via SMS...
6.18. SIM card Balance Inquiry Send SMS command "balance+password+space+carrier’s phone number+space+code" to tracker, it will forward the code to carrier’s phone number and return the balance message received from carrier’s phone number How it works: After accept balance command, tracker will remember the “mobile phone number”, carrier’s phone number and the code;...
Send “resume+password" to tracker, it will reply "Resume engine succeed", it means the oil supply is resumed. 6.21. Calibration of fuel sensor 6.21.1 Due to the difference of fuel tank height and resistive fuel level sensor specifications, tracker need to set an appropriate zero value and full range value to detect the precise fuel percentage. 6.21.2 Zero calibration: Send “...
If the car is in ignition (ACC is at “ON” position), then the car can’t enter ARM state, and siren keep silent. If engine turned off, but door is open, then the car can’t enter ARM state and siren beeps 3 times, that means door is not closed.
6.27. Alarm Function 6.27.1. Low battery alarm Send SMS “lowbattery+password+space+on”, it will send SMS “low battery+latitude/longitude” to authorized numbers 2 times in total in 15 minutes interval when voltage of battery is going to be about 3.55V. This function activates by default, send SMS “lowbattery+password+space+off” to deactivate. 6.27.2.
6.27.6. Multi-area management 6.27.6.1Set area Send SMS command "area+password+space+latitude,longitude+space+areaname,distanceM" to tracker(distance unit: M for meter, K for kilometer), it will reply "area01 ok". For Example: Send "area123456 22.353648,113.543678 school,800M". Note: 5 areas at most and the distance between two points can't be less than the total distance in the 2 commands, and different areas can't cover each other 6.27.6.2Delete area Send SMS command:"noarea+password+space+area name”...
“speed+080!+ latitude & longitude” to the authorized numbers ,it will only send one SMS in 3 minutes in SMS mode when overspeed ; the siren will beep 1 time when overspeed 1 time. Cancel: Send SMS “nospeed+password” to deactivate the overspeed alarm. Note: The recommended speed should be not less than 30km/h.
Alarm without GSM network service 6.28.4. When the car is arm state and in the place without GSM network service, siren will be sound under non-silent mode if alarm is triggered (door, sensor, ACC), but no SMS alarm will send to authorized number.
6.30. Start Work on specific time Send "schedule+password+space+1h"to tracker, it will awake every one hour and send position info. (m:minute,h:hour,d:day) The time interval is in 3 digits at most and should be less than 30days. GSM & GPS module shut off, trackers work under low power consumption mode. Neither calling nor SMS can awake tracker device.
reply “time OK” For example: Send SMS “time zone123456 8”, 8 is Chinese time zone, If your country time zone is minus, send SMS “time zone123456 -8”. 6.34. Reset Hardware Send SMS “reset+password” to tracker device, it will reply “reset ok”. And the GSM module and GPS module in the tracker will be reset.
the tracker in SMS. For exsample: send SMS “up123456 jonnes 666666” to the tracker, and if succeeded, the tracker returns “user, password OK” Note: 123456 is tracker device password, jonnes is the user name for GPRS login, 666666 is the password for GPRS login.
setup as authorized number. Cancel: Send “nocenternum+password” to tracker, it will reply “no center num ok”. 6.40. Instructions for web platform and mobile APP Users need to regsiter an account on www.gpstrackerxy.com before use web or APP platform, account name and password is the same on web/APP platform. register an account 6.40.1.
Page 23
4. Input the newly registered user ID and password, click "login" Add a terminal 6.40.3. 5. add terminal 6. add terminal 7. enter IMEI 8. Device name 9.choose location icon 10. Save 11. the newly registered device is offline in grey color Configure 6.40.4.
Step 3:set IP and port, please use the corresponding IP and port of the server you choose, refer to 6.36.3 Step 4:switch to GPRS mode,refer to 6.36.4 12.After receiving GPRS OK, wait about one minute, tracker will be online in green color, you can operate the tracker, 6.40.5.
Please comply with the instructions to extend the unit life: 1. Keep the unit dry. Any liquid, i.e. rain, moisture, may destroy or damage the inside circuitry. 2. Don’t use & store the unit in dusty places. 3. Don’t put the unit in overheated or overcooled places. 4.
Need help?
Do you have a question about the TK303 and is the answer not in the manual?
Questions and answers