Display; Lock - D&B D80 Manual

d&b D80 Manual 1.8 en

9.5.1.1. Display

The «Display» tab provides the following display options.
Backlight
Enables the following optional settings:
Off
The display brightness is set to 1 (minimum
brightness).
On
The backlight is permanently on.
Timeout
The display is illuminated when the encoder is
10s
pressed or when the display is touched. The light
switches off automatically 10 seconds after the
last operation.
Note: This setting is recommended to increase the lifetime of
the display.
Brightness
Enables adjustment of the display brightness in the range from 1 to
10. The default setting is 8.
Touch beep
Enables or disables the beep sound when using the touch screen.
Touch screen calibration
Due to mechanical impact or the aging process of the Touch
screen, its calibration references can be changed.
An indication for this is, when tapping a dedicated button the
adjacent button is activated. Or when individual buttons are no
longer operable.
In such cases, the Touch screen should be recalibrated.
To calibrate the Touch screen proceed as follows:
1. Select «Touch screen calibration».
Þ The Screen calibration menu will be opened guiding you
through the calibration procedure.
2. Follow the on screen instructions respectively.

9.5.1.2. Lock

Selecting the «Lock» tab opens the corresponding subscreen which
enables different protection settings.
Mode
Selecting «Mode» toggles between two options to protect the
device against unintentional operation.
Press knob 2s Prevents accidental operation by locking the
front panel controls.
Password Enables password protection to prevent
operation by unauthorized persons.
Screen
Selecting «Screen» allows two different settings for the screen
when the device is locked.
43