Advanced features table CTI/8 Connection details Diagnostic LEDs Intellex DVR controlling domes up the coax via CTI/8 telemetry interface DVX to CTI/8 driving RX100/VCL Vicon matrix controlling CTI/8 with 360 Vision domes 2060 Dennard domes with up the coax control & 4 local alarms Philips Bi-Phase matrix to CTI/8 driving an RX55X CTI 8 Manual V15.2 July 2010.doc...
PRE-INSTALLATION CHECKS AND SAFETY PROCEDURES Unpacking - Inspect the packaging for signs of damage. If damage has occurred, advise the carrier and/or the suppliers immediately. Unpack the receiver carefully and check that all the items are present and correct (see checklist on box). If any item is missing contact the supplier. Retain Packaging - The shipping carton is the safest container in which to transport the unit.
- 1. Added support for Philips RS485 Protocol Version 1 11 November 2005 - 1. CTI/16 Released Support of BBV, Dennard, Philips, Pelco P & D and VCL RS485 input protocols converting to BBV Coax output protocol CTI 8 Manual V15.2 July 2010.doc...
Test Mode This feature enables the Camera to be driven left or right from the Coax Telemetry Interface directly. SW2 Sets Test Mode SW1 Sets Camera Number & Direction 7 ON = Pan Left 8 ON = Pan Right SW1 Cam 1 Pan Left SW1 Cam 2 Pan Left SW1 Cam 3 Pan Left SW1 Cam 4 Pan Left...
Setting the Protocol and baud rate The CTI/8 will only output BBV Coax Telemetry on the 8 Coax output channels The CTI/8 supports various RS422/485 input Protocols SW2 Sets Protocol & Baud Rate SW1 Sets Address & Parity 7 & 8 OFF = None Parity 7 &...
Address Settings A maximum of 16 x CTI/8 can be cascaded together N.B. Refer to input Protocol documents for maximum address supported i.e. Pelco P max addr = 32 Address Range 1 - 8 SW1 Sets Address Address Range 17 - 24...