Oregon Scientific TG513 Manual

DRONE FIGHTER
Features
• Drone Combat Mode
• Six-Axis Gyro
• Auto-stabilize feature
• USB charging
Package Contents
• Drone (2) • Remote Control (2)
• USB Charging Cable (2 ) • Spare Propellers (4)
• User's Guide
Specifications
Power ................................................................................................
Drone ..................................... 3.7V lithium polymer battery
Remote Control........................................ 4 × AAA batteries
Control Distance ....................................................65 ft. (20m)
Specifications are subject to change and improvement
without notice. Actual product may vary from the
images found in this document.
Fly Safely
•When flying outdoors, keep the drone away from
power lines, trees, water, and other obstacles.
•When flying indoors, keep the drone away from walls,
air conditioning, air vents, fans, breakable objects, and
other obstacles.
•Do not fly the drone near or at other people or animals.
•Keep eyes, hands, hair, and loose clothing away from
moving propellers.
• Adult supervision is recommended at all times.
Charge the Drone
1.Set the drone's ON/OFF switch to OFF .
ON/OFF
CHG
LED
2.Connect the included USB charging cable to the
drone's CHG jack and a USB power source. The USB
connector LED lights red during charging, and turns
off when charging is compoete. A full charge takes
about 50 minutes, and gives you up to 5 minutes
flight time.
3.After charging, unplug the charging cable.
CAUTION
•Use only the included USB charging cable to charge
the drone's battery. Other cables may damage the
drone.
•Always let the drone battery cool before recharging.
Infrared RC Battle Drone
Lithium Battery Notes
Your drone uses a built-in lithium polymer battery for power. Follow the
instructions for charging.
•Do not charge longer than recommended. Unplug the charging cable
when the drone is charged.
•Do not puncture or crush. Do not disassemble.
•Do not dispose of lithium batteries in the trash.
•If the electrolyte in the cells should get on your skin, thoroughly wash
with soap and water. If in the eyes, rinse thoroughly with cool water.
Immediately seek medical attention.
•Do not attempt to charge or operate damaged toys.
Install Batteries in the Remote Control
1.On the remote control, set the ON/OFF switch to OFF
2.Use a screwdriver to open the twin battery compartments. Then insert
four AAA batteries (not included), matching the polarities (+ and –)
marked inside. Replace the cover.
Note: If the remote control's LED flasher during use, the batteries are
low and
should be replaced.
Battery Notes
•Dispose of old batteries promptly and properly. Do not burn or bury
them.Use only fresh batteries of the required size and recommended type.
•Do not mix ole and new batteries, different types of batteries (standard,
alkaline, or rechargeable), or rechargeable batteries of different capacities.
•Remove batteries during longer storage periods. Batteries can leak
chemicals that can damage electronic parts.
Multiple Fire
Age 14+
Throttle
Ascend
Push
(stunt
Turn left Turn right
mode)
Descend
Pairing
Switch on and pair one drone and remote control at a time.
1.Turn on the drone. The drone's LEDs flash.
2.Place the drone on level ground.
3.Turn on the remote control. The remote control' LED flashes.
4.Move the throttle all the way up and then down to pair the remote control with the drone. The drone's
propellers remain still during pairing. When paired, the LEDs on both the remote control and drone light
steadily.
Note:If pairing fails, turn off the drone and remote control and repeat the steps above, or change locations to
avoid interference.
Fly Your Drone
1.After pairing, push the steering control in to switch between high speed (double beep) and low speed (single
beep).
2.With the drone on the ground, move the throttle forward to ascend. To avoid turbulence, fly the drone at
least 1 ft. (30cm) off the ground.
For advanced users: Hold the remote control with one hand, resting your thumb on the throttle. Throw the
drone about 9 ft.(3m) away from you, and move the throttle forward to fly. The drone adjusts itself
automatically and flies smoothly.
IMPORTANT: If your drone lands upside down, pull the throttle all the way down. Wait for the propellers to
stop before touching the drone.
Trim Your Drone
Move the throttle forward and see how the drone reacts.
Reverse/ Forward Movement Trim: If the drone tends to move forward, press f ; if it tends to move
backward, press g.
Left/Right Slide Trim: If the drone tends to slide right, press f ; if it tends to slide left, press g.
Note: The remote control beeps when you press a trim control, but stops beeping when you reach maximum
trim adjustment.
Slide Trim
Movement Trim
Left
Forward
/
/
Reverse Right Single fire
 
Spin left
LED
OFF/ON
Steering
Forward
Push
(High/ Spin right
low speed)
Backward