AEG L75670NWD User Manual page 4

4 www.aeg.com
Connect the mains plug to the mains socket only at
•
the end of the installation process. Make sure that the
mains plug is accessible after installation.
The ventilation opening in the base (if applicable)
•
must not be covered by a carpet, mat, or any floor
covering.
Ensure good air ventilation in the located room to
•
avoid the backflow of unwanted gases into the room
from appliances burning gas or other fuels, including
open fires.
Exhaust air must not be discharged into a flue which is
•
used for exhausting fumes from any appliances
burning gas or other fuels.
The operating water pressure at the water entry point
•
from the outlet connection must be between 0.5 bar
(0.05 MPa) and 8 bar (0.8 MPa).
Do not exceed the maximum load of 7 kg (refer to the
•
"Programme chart" chapter).
The appliance must be connected to the water mains
•
using the new supplied hose sets, or other new hose
sets supplied by the Authorised Service Centre.
Old hose sets must not be reused.
•
If the mains power supply cable is damaged, it must
•
be replaced by the manufacturer, its Authorised
Service Centre or similarly qualified persons to avoid
an electrical hazard.
Wipe away lint or packaging debris that has
•
accumulated around the appliance.
Items that have been soiled with substances such as
•
vegetable or mineral oil, acetone, alcohol, petrol,
kerosene, spot removers, turpentine, waxes and wax
removers should be washed separately with an extra
amount of detergent before being dried in the washer
dryer.
Do not use the appliance if items have been soiled
•
with industrial chemicals.
Do not dry unwashed items in the wash dryer.
•