Aixam SV43AF Owner's Manual page 44

REPLACING A LIGHT BULB
1. Parking light bulb
- Pivot the bulb's support a quarter turn toward the left
and remove it.
- Remove the bulb by pulling on it to replace it.
- Place the bulb support back taking care that the
polarizer (one big, one small) are located facing the
corresponding notches on the back of the headlight.
- Make it pivot a quarter turn to the right by applying
pressure so as to pin the joint.
2. Dipped and full beam bulb
- Remove the headlight's cover. To unlock it, press the
upper clip and remove it.
- Remove the sealing bonnet from the rear of the
headlight and by pulling on it, remove the bulb's
socket.
42
- Press the bulb's locking wire by sliding it to the right and
lowering it.
- Remove the bulb.
- Put the new bulb in place making sure that its pins enter
correctly in their housing (do not touch the glass part of
the bulb with the fingers).
- Put the locking wire back and press on it while making it
slide to the left.
- Reposition the sealing bonnet on the bulb's socket.
- Insert the bonnet on the headlight's rear part.
- ATTENTION: take great care in doing the two previous
procedures, otherwise water will penetrate in the
headlight and damage it.
- Insert the protection cover on the bonnet taking care that
the notch allowing the passage of the electric bundle is
quite vertical, otherwise the clip cannot engage and you
risk losing the cover.
3. Direction lights
- Pivot the bulb support a quarter turn to the left and
remove it.
- Press on the bulb while pivoting it to the left and remove
it.
- Place the new bulb on the support by aligning its pins
facing the notches of the support, press on it while
making it pivot to the right.
- Put the bulb support back on the headlight by positioning
its polarizer (one big, one average, one small) facing the
headlight's notches.
- Press on the bulb's support and make it pivot a quarter
turn to the right.