Station Preset Memory; Auto Memory Entry; Preset Tuning; Frequency Step Setting - Kenwood KDC-MP8029 Instruction Manual

3
Enter the frequency
Press the number buttons on the remote.
Example:
Desired frequency Press button
92.1 MHz (FM) [0], [9], [2], [1]
810 kHz (AM) [0], [8], [1], [0]
Canceling Direct Access Tuning
Press the [DIRECT] button on the remote.

Station Preset Memory

Putting the station in the memory.
1
Select the band
Push the Control knob to [FM] or [AM].
2
Select the frequency to put in the memory
Push the Control knob to [4] or [¢].
3
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "[1]" — "[6]" are
displayed above the [1] — [6] buttons.
Refer to <Notes on Multi-function Key System>
(page 8).
4
Put the frequency in the memory
Press the desired [1] — [6] button for at least
2 seconds.
The preset number display blinks 1 time.
On each band, 1 station can be put in the
memory on each [1] — [6] button.

Auto Memory Entry

Putting stations with good reception in the
memory automatically.
1
Select the band for Auto Memory Entry
Push the Control knob to [FM] or [AM].
2
Open Auto Memory Entry
Press the [AME] button for at least 2 seconds.
When 6 stations that can be received are put in
the memory Auto Memory Entry closes.

Preset Tuning

Calling up the stations in the memory.
1
Select the band
Push the Control knob to [FM] or [AM].
2
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "[1]" — "[6]" are
displayed above the [1] — [6] buttons.
Refer to <Notes on Multi-function Key System>
(page 8).
3
Call up the station
Press the desired [1] — [6] button.

Frequency Step Setting

Changing the tuning frequency step.
The original setting is FM band 50 kHz, and AM
band 9 kHz.
1
Turn the power OFF
Press the [SRC] button for at least 1 second.
2
Switch the frequency step
While pressing the [1] and [5] button, press
the [SRC] button.
Release your fingers from the button after the
display is appeared.
The frequency step changes to FM band 200 kHz,
and AM band 10 kHz.
• When the same operation is repeated, it returns to the
original setting.
• When the frequency step is switched, the frequencies
in the memory are deleted.
23
|
English