Advertisement
Table of Contents
Replacing the brake pads
Remove the battery before performing any maintenance on your eBike.
Make sure that all screws are tightened securely before using your eBike.
Close the brake arms using your thumb and index
finger and lift out the brake cable.
Remove the old brake pad. Make sure to keep any
screws and washers.
www.gtech.co.uk
Brake Pad Instructions
Loosen the brake pad fixing bolts.
Insert the new brake pad. Screw the new brake
pad into place.
Page 1 of 4
Advertisement
Table of Contents
Summary of Contents for Gtech Brake Pad
- Page 1 Close the brake arms using your thumb and index Loosen the brake pad fixing bolts. finger and lift out the brake cable. Remove the old brake pad. Make sure to keep any Insert the new brake pad. Screw the new brake screws and washers.
- Page 2 Brake Pad Instructions Hold the brake pad so that its whole surface rests Close the brake arms using your thumb and index against the wheel rim and re-tighten the screws. finger and put the brake cable back in place. It is absolutely essential to remember to adjust the brakes after replacing the pads.
- Page 3 Loosen the brake pad fixing bolts. finger and lift out the brake cable. Straighten the brake pad and make sure that it is Hold the brake pad in the correct position against at the right height, so that the whole of its surface the wheel rim and re-tighten the screws.
- Page 4 Brake Pad Instructions Close the brake arms using your thumb and index finger and then put the brake cable back in place. Page 4 of 4 www.gtech.co.uk...
Need help?
Do you have a question about the Brake Pad and is the answer not in the manual?
Questions and answers