Campbell Hausfeld CL15 SERIES Operating Instructions Manual page 7

Impact Mechanism Troubleshooting Guide
Symptom
Impacts slowly or
will not impact
Impacts rapidly
but will not
remove bolts
Does not impact
Possible Cause(s)
1. Lack of lubrication
2. Tool regulator set in
wrong position
3. In-line regulator
or compressor
regulator set too
low
1. worn impact
mechanism
1. Broken impact
mechanism
www.campbellhausfeld.com
Cl15xx and Cl25xx series
Corrective Action
1. Lubricate the air motor and the impact
mechanism. (See Lubrication section of this
manual)
2. a. Adjust the regulator on the tool to the
maximum setting
b. For twin hammer impact, the regulator
should be turned so the indicator points
to a number on the tool
3. Adjust regulators in the air system
1. a. Replace worn impact mechanism
components
b. Return impact wrench to Authorized
Campbell Hausfeld Service Center for
repair
1. a. Replace worn impact mechanism
components
b. Return impact wrench to Authorized
Campbell Hausfeld Service Center for
repair
7