Pioneer SX-S30 Owner's Manual page 33

> Before Start > Part Names
∫ Analog Audio Input
You can change input assignment between the input selectors and AUDIO IN jacks. If you
do not assign a jack, select "-----".
BD/DVD "AUDIO 1" to "AUDIO 2": Assign a desired AUDIO IN jack to the
BD/DVD input selector. (Default Value is "AUDIO 1")
CBL/SAT "AUDIO 1" to "AUDIO 2": Assign a desired AUDIO IN jack to the
CBL/SAT input selector. (Default Value is "AUDIO 2")
GAME "AUDIO 1" to "AUDIO 2": Assign a desired AUDIO IN jack to the
GAME input selector. (Default Value is "-----")
STRM BOX "AUDIO 1" to "AUDIO 2": Assign a desired AUDIO IN jack to the
STRM BOX input selector. (Default Value is "-----")
CD "AUDIO 1" to "AUDIO 2": Assign a desired AUDIO IN jack to the
CD input selector. (Default Value is "-----")
TV "AUDIO 1" to "AUDIO 2": Assign a desired AUDIO IN jack to the
TV input selector. (Default Value is "-----")
Speaker
You can make changes to the connection environment of the speakers and change the
volume level. Settings are automatically configured if you use Full Auto MCACC. This setting
cannot be selected if headphones are connected or audio is output from the speakers of the
TV because "Hardware" - "HDMI" - "Audio TV Out" is set to "On".
∫ Configuration
Subwoofer Set whether a subwoofer is connected or not.
"Yes (Default Value)": When subwoofer is connected
"No": When subwoofer is not connected
32
> Install > Initial Setup > Playback
∫ Crossover
Front Set the low range capabilities for each channel by setting either
small or large.
"Small (Default Value)": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low range
capabilities
0 If "Configuration" - "Subwoofer" is set to "No", "Front" will be
fixed to "Large" and the low pitched range of the other
channels will be output from the front speakers. Refer to the
instruction manual of your speakers to make the setting.
Crossover When there are speakers that have been set to "Small", set the
Hz under which you would like other speakers to play bass, and
also set Hz under which you would like the LFE (low frequency
effect) to play the bass.
0 The value from "50Hz" to "200Hz" can be set. (Default Value
is "80Hz")
Double Bass This can be selected only when "Configuration" - "Subwoofer" is
set to "Yes" and "Front" is set to "Large".
Boost bass output by feeding bass sounds from the front left and
right speakers to the subwoofer.
"On": Bass output will be boosted
"Off": Bass output will not be boosted
0 The setting will not automatically be configured even if you
performed Full Auto MCACC.
Advanced Setup | Firmware Update | Others
E
N