Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for MOTY-KO 14DD
- Page 1 MOTY- KO Model #’s 14DD/18HD CORDLESS HAMMER DRILL / DRILL INSTRUCTION MANUAL LMD, LLC. www.motyko.com WARNING: 1445 Brookville Way, Suite J, Indianapolis, IN 46239 Please read the following instruction carefully before the tool used. TEL: 317-322-5265 FAX: 317-322-5205...
-
Page 2: General Safety Rules
TOOL AND CHARGER USE GENERAL SAFETY RULES DON‘T FORCE TOOL. It will do the job better and safer at the rate for PERSONAL SAFETY which it was intended. USE SAFETY GLASSES. Use a face or dust mask if operation is dusty. USE RIGHT TOOL. -
Page 3: Battery Charger
Do not attempt to use it on any other voltage! Do not expose charger to rain or snow. The charger is not intended for any uses other than charging MOTY-KO rechargeable batteries. Any other uses may result in risk of fire, electric IMPORTANT SAFETY INSTRUCTIONS FOR shock or electrocution. -
Page 4: Important Charging Notes
Protection Agency to find out about special restrictions on the disposal of CAUTION: Never attempt to open the battery pack for any reason. If the these battery packs or return them to a MOTY-KO certified service center plastic housing of the battery pack breaks or cracks, return to a service center for recycling. - Page 5 and permit to stop. Slide the gear shifter back (away from chuck). FORWARD / REVERSE CONTROL BUTTON : Do not change gears when the tool is running. If you are having trouble A forward/reverse control button determines the direction of the tool and also changing gears, make sure that the dual range gear button is either completely serves as a lock off button.
-
Page 6: Normal Charging
until it stops. clockwise until the bit is gripped in the chuck. 4. Tighten the chuck by turning the sleeve (A) clockwise. Tighten securely. The red light (see Fig. 6B), should begin to glow continuously, indicating that the battery pack is receiving a “Fast Charge” (if the red light does not glow 5. -
Page 7: Chuck Installation
INSTALLING OR REMOVING BATTERY PACK CHUCK INSTALLATION TO REMOVE BATTERY PACK : Depress the battery release button (see Fig. Screw the chuck on by hand as far as it will go and insert screw (LH 8B), and pull battery pack out of tool. thread). -
Page 8: Specification
Concrete Wood Steel DRILLING MASONRY Use carbide tipped masonry bits at low speeds. Keep even force on the drill but 14DD 14.4V 0-360/0-1150 1 Hr 4.70 not so much that you crack brittle materials. A smooth, even flow of dust indicates the proper drilling rate.
Need help?
Do you have a question about the 14DD and is the answer not in the manual?
Questions and answers