Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Lumantek Manuals
  4. Remote Control
  5. SIRCH
  6. Installation manual

Lumantek SIRCH Installation Manual

Samsung interactive remote control for hospitality
Hide thumbs

Advertisement

Quick Links

Download this manual
SIRCH(Samsung Interactive Remote Control for Hospitality)
Installation Guide
March 2011
Version 0.8
LUMANTEK Co., Ltd.

Advertisement

loading
Need help?

Need help?

Do you have a question about the SIRCH and is the answer not in the manual?

Questions and answers

Summary of Contents for Lumantek SIRCH

  • Page 1 SIRCH(Samsung Interactive Remote Control for Hospitality) Installation Guide March 2011 Version 0.8 LUMANTEK Co., Ltd.
  • Page 2 Radio Frequency Interference Statement NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.

  • Page 3: Installation Process

    Introduction This guide explains how to install a SIRCH in a existing cable network. You should be familiar with cable TV systems. Some of the operations described by this guide could disrupt the entire cable TV system if performed improperly.

  • Page 4: Installation Example

    SIRCH output power can be controlled from 29dBmV to 56dBmV. And, the output power must match with other combined RF signals. Case #1. In case the output power of SIRCH input into combiner, the output power should be same with other signal powers input to the Combiner. Case #2.

  • Page 5: Front Panel Operation

    Front Panel Operation Front and rear view Cursor Keys POWER LCD Display RESET ESC / ENTER Key Air Intake Air Intake AC Power Inlet RF OUT AC Power Switch VGA Monitor POWER Button: System power on/off switch RESET Button: Reset the system immediately ENTER Key: Menu display or select item ESC(Escape) Key: Escape from sub/main menu and cancel current input.
  • Page 6 -> 1. Frequency -> 2. Level -> 3. IPv4 Setting -> 4. Version Select the ‚1. Frequency‛ menu with up/down cursor keys and push [Enter] button, the Frequency menu will be displayed on LCD, as below. Frequency 602.000MHz [50 ~ 870MHz / 1kHz] Set the desired frequency using the cursor keys.
  • Page 7 To connect your host computer, which is the client (or remote) computer to a SIRCH, you need to set up your host computer’s TCP/IP setting to be in a same subnet with the SIRCH. Refer to the below steps for Windows 7 Open Network Connections by clicking the Start button, and then clicking Control Panel.
  • Page 8 Right-click the connection that you want to change, and then click Properties. If you're prompted for an administrator password or confirmation, type the password or provide confirmation. Click the Networking tab. Under This connection uses the following items, click either Internet Protocol Version 4 (TCP/IPv4) or Internet Protocol Version 6 (TCP/IPv6), and then click Properties.
  • Page 9 To specify DNS server address settings, do one of the following:  To get a DNS server address automatically using DHCP, click Obtain DNS server address automatically, and then click OK.  To specify a DNS server address, click Use the following DNS server addresses, and then, in the Preferred DNS server and Alternate DNS server boxes, type the addresses of the primary and secondary DNS servers.
  • Page 10 2. In the Computer box, type the name of the SIRCH that you want to connect to, and then click Connect. (You can also type the IP address instead of the computer name.)