Contents WHAT’S IN THE BOX BE SPORT3 EARPHONES THE BASICS Charging your BE Sport3 Checking battery level Bluetooth pairing Power On/ Power Off Wearing your BE Sport3 Handling phone calls Listening to music Pairing with a laptop Pairing with a Mac ...
WHAT’S IN THE BOX BE Sport3 earphones (with inline controller and microphone) Silicon tips (in L/M/S) 2 types of silicon tips Total of 6 pairs ear tips SpinFit TwinBlade tips (1 pair) Stabilizers (in L/M) 3 colors, total of 6 pairs...
2. The charge cable should be connected to the charge port and either to a PC or a dedicated USB charger. 3. When charging, the LED indicator is red. 4. LED Indicator turns blue once charging is complete. NOTE: It takes up to 2.5 hours to fully charge the BE Sport3.
Checking Battery Level You can check the battery level of your BE Sport3 with the LED indicator To check battery level: 1. Press the Power/Function, volume up, and volume down buttons simultaneously. 2. The LED indicator will flash red and blue simultaneously. The...
3. Once successfully paired, the LED indicator will flash blue and you hear “Primary device connected” (when voice prompt enabled) from your BE Sport3, or a beep if voice prompt is not enabled. Please note: A. You must always enter “Pair” mode from a powered-off state.
B. If left inactive in pairing mode, your BE Sport3 will automatically power off after 3 minutes. C. Your BE Sport3 can store pairing information for up to eight devices. To pair additional devices to your BE Sport3 ensure that your BE Sport3 is not concurrently connected to any device, then repeat the steps 1,2,3 outlined above.
For more information read section “Multipoint Connections”. To turn the BE Sport3 to OFF, push Power/Function button for about 3 seconds until the LED indicator turns red and you hear the “Power off” ” when voice prompt be activated or a beep if the voice prompt is not used.
Play previous track Press the Volume Down button for 2 seconds Adjust the volume Tap the volume up or volume down button Please note: when muting the BE Sport3 or reactivating it from MUTE there will be a very slight delay...
3. Switch your laptop Bluetooth to “On” 4. Turn the BE Sport3 to “Pairing Mode” 5. When the BE Sport3 is discovered by your laptop left click on “Pair” 6. Right click on the speaker symbol at the bottom right side of the screen 7.
3. Click on the Bluetooth symbol 4. Turn the Optoma NuForce BE Sport3 to “Pairing Mode” 5. When the Optoma NuForce BE Sport3 is discovered by your Mac click on “Pair” Your Mac is now ready to play audio via the BE Sport3...
BE Sport3 via its operating system. • The BE Sport3 will prioritize the audio from Primary device. • You can control Primary device using the BE Sport3 in line controller. • When Primary device is idle, your BE Sport3 can receive audio from Secondary device.
Press the Power/Function and Volume Up buttons simultaneously for 2 seconds Turn off voice prompt Press the Power/Function and Volume Down buttons simultaneously for 2 seconds Disclaimer Please be advised, the BE Sport3 is equipped with the latest technology however functionality may vary by device.
Page 15
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
EU Regulatory Conformance Hereby, Optoma Corporation declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. Notice: Observe the national local regulations in the location where the device is to be used.
Specification Connection type Bluetooth 2.4Ghz Bluetooth type V4.1 HSP 1.2, HFP 1.6, A2DP 1.2, AVRCP 1.4 , Bluetooth profile aptX, AAC Codec SBC, aptX, AAC Cable length 580 +/- 20 mm Driver Type Dynamic Driver size 6 mm Impedance 16 Ohm Battery life (estimated) Up to 10 hours Lithium-ion battery, Cylindrical Type,...
Need help?
Do you have a question about the BE Sport3 and is the answer not in the manual?
Questions and answers