Operating Instructions - Omega 82003 Operating Instructions Manual

Operating Instructions

Installing or Removing Battery Pack
1. Always switch off the machine before insertion or removal of the battery pack.
2. To remove the battery pack, push the button on the battery pack and pull battery away from tool.
3. To insert the battery pack, align the slides on the tool unit with the battery pack sliding groove and push the tool
unit into place.
4. Do not force the battery pack in sliding it into tool unit. If the battery pack does not slide in easily, it is not being
inserted correctly.
Installing Or Removing Socket
Caution: Always be sure that the machine is switched off and the battery pack is removed before installing or
!
removing the socket.
1. To install the socket, push the socket onto the anvil as far as it will go. (See Fig. 2)
2. To remove the socket, simply pull the socket from the anvil.
3. To start the machine, pull the trigger. Machine speed is increased by increasing pressure on the trigger. Release
the trigger to stop.
4. To reverse the direction, (See Fig. 3) use the forward / reverse button on the drive unit.
5. The tool has two torque settings that can be selected from dial on rear of unit (See Fig. 4).
!
Caution: Always check the direction of rotation before operation.
Caution: Use the forward/reverse button only after the machine comes to a complete stop. Changing the
!
direction of rotation before the tool stops may damage the tool.
Fig. 2 Installing socket on anvil.
Fig. 3 Forward/Reverse Button.
Fig. 4. Torque adjustment knob.
4